Ensure that an interface has been configured with an IP address
Ensure that IP classless is enabled
Ensure that the interfaces can ping their directly connected neighbors
Ensure that an interface has been configured with an IP address and is up
第1题:
A. router ospf ipv6 process - id
B. ipv6 ospf process - id
C. router ospf process - id
D. ipv6 router ospf process - id
第2题:
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()
A. Issue the show ip route command on Router A
B. Issue the show ip route command on Router B
C. Issue the show cdp neighbors command on Router B
D. Issue the show cdp neighbors detail command on Router C
E. Issue the show arp command on Router A
F. Issue the show arp command on Router B
第3题:
Router R1 connects to a Frame Relay cloud using a multipoint subinterface, with ten PVCs associated with the subinterface.What command would make this router not use a DR, and dynamically discover OSPF neighbors?()
A. ip ospf network broadcast
B. ip ospf network non - broadcast
C. ip ospf network point - to - multipoint
D. ip ospf network point - to - multipoint non - broadcast
第4题:
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? ()
第5题:
A.NVRAM
B.RAM
C.FLASH
D.ROM
E.PCMCIA
第6题:
A. Ensure that an interface has been configured with an IP address
B. Ensure that IP classless is enabled
C. Ensure that the interfaces can ping their directly connected neighbors
D. Ensure that an interface has been configured with an IP address and is up
第7题:
A.informational
B.emergency
C.warning
D.critical
E.debug
F.error
第8题:
Refer to the exhibit. EIGRP has been configured on router D. Router C is performing mutual redistribution between EI GRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause o f the problem?()
A. The no auto - summary command needs to be added under router eigrp 1
B. The subnets keyword was not included in the redistribute command under router ospf 1
C. The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A
D. The default - information originate command needs to be added under router ospf 1
E. The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF
第9题:
Which command enables OSPF for IPv6?()
第10题:
The following output was taken from Router R3. A scan of R3's configuration shows that no bandwidth commands have been configured in this router. Which of the following answers lists configuration settings could be a part of a configuration tha t results in the following output?() R3#show ip ospf interface brief Interface PID Area IP Address/Mask Cost State Nbrs F/C Se0/0/0.2 3 34 10.10.23.3/29 647 P2P 1/1 Se0/0/0.1 3 34 10.10.13.3/29 1000 P2P 1/1 Fa0/0 3 34 10.10.34.3/24 20 BDR 1/1