It immediately sends its entire routing table to its neighbors.
EIGRP sends a Hello packet to the DR to inform it of the route failure.
It automatically forwards traffic to a fallback default route until a successor route is found.
It sends queries out to neighbors until a new successor route is found.
It places the route in holddown until LSA updates inform it of a new route to the network.
第1题：
A. The no auto - summary command has not been issued under the EIGRP process on both routers.
B. Interface E0 on router R1 has not been configured with a secondary IP address of 10.1.2.1/24.
C. EIGRP cannot exchange routing updates with a neighbor‘s router interface that is configured with tw o IP addresses.
D. EIGRP cannot form neighbor relationship and exchange routing updates with a secondary address.
第2题：
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）
A. one
B. three
C. two
D. zero
第3题：
Refer to the exhibit. EIGRP has been configured on router D. Router C is performing mutual redistribution between EI GRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause o f the problem?（）
A. The no auto - summary command needs to be added under router eigrp 1
B. The subnets keyword was not included in the redistribute command under router ospf 1
C. The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A
D. The default - information originate command needs to be added under router ospf 1
E. The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF
第4题：
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）
第5题：
When EIGRP is used as the PE-CE routing protocol which of these statements is correct?（）
第6题：
A. Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.
B. Gateway-Router is configured to only receive RIPv2 updates.
C. Gateway-router is configured to receive only RIPv1 updates.
D. Branch-Router1 is configured to only send RIPv1 updates
第7题：
Which of these statements accurately identifies how Unicast Reverse Path Forwarding can be employed to prevent the use of malformed or forged IP sources addresses？（）
第8题：
A. point-to-point
B. Backbone area 0
C. Broadcast multicast
D. Non-broadcast multi-access
E. The DR/BDR process is done for all interface types
第9题：
Half of your network uses RIPv2 and the other half runs OSPF. The networks do not communicate with each other. Which two of these factors describe the impact of activating EIGRP over each separate part？ （）
第10题：
How will router A choose a path to the 10.1.2.0/24 network when different routing protocols are configured (Choose three.)（）。