You have just created a new VLAN on your network for inter-V

You need to create a new VLAN on your Catalyst switch. This VLAN is to be named EZONEXAM. Which of the following need to be completed for the creation of this new VLAN? (Select all that apply)

A. The EZONEXAM VLAN must be created.

B. The desired ports must be added to the new EZONEXAM VLAN.

C. The EZONEXAM VLAN must be added to all of the domains.

D. The EZONEXAM VLAN must be named.

E. An IP address must be configured for the EZONEXAM VLAN.

F. None of the above. VLAN creations are automatic.

The network administrator has just finished installing a new 10/100/1000 switch, but receives reports from the server administrator that servers connected to the new switch seem to be experiencing slow LAN connections. The network administrator checks the port connecting the new switch to the core switch and sees the following information:Which of the following is the MOST likely cause of the slow connections?（）

A. The servers have not had VLAN tagging enabled on their NICs.

B. Speed and duplex have not been set.

C. VLAN tagging was not set on the trunk.

D. The servers have been connected with CAT5 cable.

You are an administrator of the Ezonexam switched network and your goal is to reduce some of the administrative overhead on your network. You plan on achieving this by configuring a new VLAN for each department in the Ezonexam network.

However, you need to share the VLAN information across numerous switches. Which of the following would allow you accomplish this?

A. STP

B. GVRP

C. SNMP

D. VTP

E. DHCP

F. None of the above

A. The VLAN must be created

B. The VLAN must be named

C. An IP address and subnet mask must be configured for the new VLAN

D. The desired ports must be added to the new VLAN

E. The VLAN must be added to the existing VTP Domain

You have just issued the command commit confirmed and your network continues to be operational with no further changes required. You issue a commit and-quit. A short time later, users start complaining about network problems. Which commands (in order) need to be entered to resolve this issue?（）

A.A

B.B

C.C

D.D

A. The use of Full-Duplex Mode.

B. The Creation on New Collision Domains.

C. The Creation on New Broadcast Domains.

D. The Addition of Hubs to the Network.

E. The use of switches in the Network.

F. The Amount of ARP or IPX SAP Traffic.

You are the administrator for your company's network. The network is configured as shown in the exhibit.

You want to install Windows 2000 Professional on 20 new PXE-compliant computers on the marketing segment of your network. The new computers do not have operating systems installed.

You create a RIS image. You load the image onto the RIS server. You then start the new computers.

You find that the new computers cannot connect to the RIS server. You verify that the new computers cannot connect to the RIS server. You verify that the existing client computers in the network can connect to the network servers, including the RIS server. You want to enable the new computers to connect to the RIS server.

What should you do?

A．Add a Windows 2000 Server computer running WINS to the network.

B．Add a Windows 2000 Server computer running DHCP to the network.

C．Add the domain Everyone group to the RIS OS image security settings.

D．Place the new computers on the same segment as the RIS server.