Static
Auto-RP
Dynamic-RP
Bootstrap router
第1题:
A. Configure a non-unique address on the loopback interface for use by the PIM RP.
B. Configure MSDP with the unique address (router ID) as the local address of the peer.
C. Configure MSDP with the non-unique address (router ID) as the local address of the peer.
D. Configure a unique address on the loopback interface, used as the PIM RP.
第2题:
Which three statements about the secure domain router are true?()
第3题:
A.User Exec
B.Privileged Exec
C.Super User Exec
D.Global Configuration
E.Private Configuration
第4题:
Which two steps are needed when configuring multiple RPs using MSDP within a single PIM domain? ()
第5题:
Which two of these multicast deployments are most susceptible to attacks from unknown sources?()
第6题:
A. PIM sparse - dense mode and PIM dense mode require an RP on the network.
B. PIM sparse mode and PIM dense mode require an RP on the network.
C. PIM sparse mode interfaces are always added to the multicast routing table in a router.
D. PIM sparse mode and PIM sparse - dense mode require an RP on the network.
E. PIM dense mode interfaces are always added to the multicast routing table in a router.
F. PIM sparse - dense mode acts as PIM dense mode if an RP is not known.
第7题:
In PIM-SM operations, the first router connected to the multicast source sends the Register message towhich device?()
第8题:
A. Static
B. Auto-RP
C. Dynamic-RP
D. Bootstrap router
E. Anycast-RP
第9题:
Which method of dynamic RP election is non-proprietary?()
第10题:
Which of the following are valid methods of providing a router with information concerning the location of the RP()