单选题Due to slow backup response， an administrator installed a new driver for the SCSI card. After a server reboot the device is not working properly.  Which of the following is the BEST course of action？（）A Reboot the server and restore files using ASR.B I

第1题：

An administrator installed new components on a server. After the device installation， two of the components fail.Which of the following is the cause of the problem？（）

• A、The server was not powered off correctly.
• B、The proper ESD procedures were not used.
• C、The devices were installed in the incorrect sequence.
• D、The devices are incompatible with the system.

第2题：

A server contains a 3 disk RAID 5 array. The red LED is illuminated on one of the drives. Which of the following should the server administrator perform？（）

• A、Replace the drive
• B、Restore the drive from backup
• C、Reboot the server
• D、Reconfigure RAID 5 to RAID 10

第3题：

第4题：

A user calls the system administrator and states that they can no longer access the file server they had been working on all morning. To trouble shoot this problem，  which step should the administrator take FIRST？（）

• A、 Reboot the file server.
• B、 Ask the user what they were doing when they noticed the problem.
• C、 Ask the user to reboot their PC.
• D、 Ask the user to ping the default gateway and report the response times back to the administrator.

第5题：

Which of the following is MOST likely to occur if the temperature in the server room is cooled too quickly after a power outage？（）

• A、Server forms condensation
• B、Server will not POST
• C、Server’s services will not start
• D、Server response times are slow due to temperature change

第6题：

Users report that they are unable to connect to a server. An administrator confirms that it is unreachable across the network. Other administrators have been working in the server room throughout the day.  Which of the following is the NEXT step the administrator should take？（）

• A、 Verify the configuration of the connected port on the network switch.
• B、 Reboot the server.
• C、 Install a new NIC on the server.
• D、 Verify that network cables are connected.

第7题：

Which of the following actions will prevent a driver from being reinstalled automatically?（）

• A、Run the disable command.
• B、Disable the device using Device Manager.
• C、Review manufacturer manual.
• D、Reboot the server, logon in Safe Mode, uninstall the driver.

第8题：

A server administrator recently purchased a new brand of rewritable Blu-ray media and is now having problems backing up data when using the Blu-ray burner installed in the server. Older backup disks still work， but the new media causes the backup software to report burn failures.Which of the following is the BEST solution to resolve the problem？（）

• A、Update the Blu-ray burner to the latest drivers
• B、Reboot the server and restart the software
• C、Upgrade the firmware on the Blu-ray burner
• D、Apply the latest operating service pack

第9题：

An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS， but it does not receive an IP address. Which of the following is the MOST likely cause of this？（）

• A、The NIC is not on the HCL.
• B、The driver is incorrect on the server.
• C、The patch cable has not been seated properly.
• D、The NIC is not seated properly.

第10题：

After applying a new driver to a NIC, the server reboots and fails to restart. Which of the following is the BEST way to resolve the problem?（）

• A、Boot using recovery console and restore the previous driver.
• B、Boot the server, press F8 and access last known good configuration.
• C、Restore the server using last backup tape.
• D、Boot the server with ASR option.