Configure the switch to be in VTP client mode.
Configure the switch to be in VTP domaint mode.
Configure the switch to be in VTP transparent mode.
Configure the switch to be in VTPv2.
第1题:
A. Configure the switch to be in VTP client mode.
B. Configure the switch to be in VTP domaint mode.
C. Configure the switch to be in VTP transparent mode.
D. Configure the switch to be in VTPv2.
第2题:
A.Switch3
B.Switch4
C.Switch2
D.Switch1
第3题:
A.0
B.1
C.1024
D.4096
第4题:
Refer to the exibit. Three cisco 2950 switches are set to their default priority sttings.During the spanningtree process,which switch will be elected as the root bridge?()
第5题:
You need to set the default gateway of one of your TestKing switches. Which command will set the default gateway to 192.168.12.1 on a Cisco switch?()
第6题:
A.2 through 1001
B.1 through 1001
C.1 through 1002
D.2 through 1005
第7题:
A.Enable VTP pruning
B.From privileged mode,erase the startup configuration file,then reload.
C.From privileged mode,erase the vlan date file,then reload.
D.Cycle the switch power.
第8题:
A. Switch(config)# ip default-network 192.168.12.1
B. Switch(config)#ip route-default 192.168.12.1
C. Switch(config)# ip default-gateway 192.168.12.1
D. Swicth(config)# ip route 192.168.12.1 0.0.0.0
第9题:
assuming the default switch configuration which vlan range can be added modified and removed on a cisco switch?()
第10题:
An SVI has been configured on a device. Which two statements are true about a switched virtual interface (SVI)?()