The command is used to establish a static route.
The default administrative distance is used.
The command is used to configure the default route.
The subnet mask for the source address is 255.255.255.0
The command is used to establish a stub network
第1题：
To make OSPF area 4 totally stubby, the following command was issued on the ABR in router configuration mode: area 4 stub.Which two things need to be done to finish making area 4 a totally stubby area?（）
A. Apply the area 4 stub command to all routers in the area
B. On the ABR, use the area 4 stub command with the no - summary keyword
C. On the ABR, specify a default cost for the area with the area default - cost command
D. On the ABR, use the default - information originate command to inject a default route into area 4
E. Use the auto - cost command on each router in the area to automatically determine the cost to other OSPF areas
第2题：
A. The default administrative distance is used.
B. The command is used to establish a static route.
C. The command is used to configure the router interfaces.
D. The command is used to establish a stub network.
E. The subnet mask for the source address is 255.255.255.0
第3题：
What will cause a Ezonexam router to enter setup mode? (Choose two)
A. The configuration file is missing in NVRAM.
B. The configuration register is set to 0x2100.
C. Boot system commands are misconfigured in the running-configuration.
D. The setup command was issued from the privileged mode prompt.
E. The IOS is missing.
F. The IOS is corrupt.
第4题：
You are preparing to create a point to point WAN by connecting a Cisco router with a Juniper router by way of their serial links. Which one of the following commands would you use?（）
第5题：
On router R1， which three of the following protocols will be forwarded to a host specified by the "iphelper-address" interface configuration command if the configuration has not been modified by the"ip forward-protocol udp" global configuration command？（）
第6题：
A. TK1(config-if)# encapsulation hdlc ansi
B. TK1(config-if)# encapsulation ppp
C. TK1(config-if)# encapsulation LAPD
D. TK1(config-if)# encapsulation frame-relay ietf
E. TK1(config)#encapsulation ppp
第7题：
The following configuration command was issued on router TK1:ip route 172.16.3.0 255.255.255.0 192.168.2.1.Which of the following statements are true regarding this command?（）
第8题：
A. Update the configuration logs
B. Update the network wiring schematics
C. Update the network configuration procedures
D. Compare the configuration with the baseline
第9题：
The following output was taken from Router R3. A scan of R3's configuration shows that no bandwidth commands have been configured in this router. Which of the following answers lists configuration settings could be a part of a configuration tha t results in the following output?（） R3#show ip ospf interface brief Interface PID Area IP Address/Mask Cost State Nbrs F/C Se0/0/0.2 3 34 10.10.23.3/29 647 P2P 1/1 Se0/0/0.1 3 34 10.10.13.3/29 1000 P2P 1/1 Fa0/0 3 34 10.10.34.3/24 20 BDR 1/1
第10题：
Which statement is true about the command ipv6 ospf 1 area 0?（）