Install one drive on the first channel and install the second drive on the second channel.
Install one drive on the first cable, on the first channel. Install the second drive on the secondcable, on the second channel.
Install both drives on the same channel. Cable both drives as the primary master on the samecable.
Install both drives on the same channel. On the same cable one drive should be set as primaryslave and the other drive as the primary master.
第1题:
An administrator buys a new server. The server has four disks and needs to be configured formaximum space. Fault tolerance is not a constraint. Which of the following configurations completes this task?()
第2题:
An administrator notes that after a recent power outage, some open files were corrupted on one affected file server. Which of the following items should the administrator consider to determine the cause of this corruption?()
第3题:
An administrator is experiencing availability issues on a Linux server. The administrator decides tocheck the server for an IP address conflict on the server. Which of the following commands should the administrator use?()
A.traceroute
B.tracert
C.ifconfig
D.ipconfig
第4题:
An administrator notes that after a recent power outage, some open files were corrupted on oneaffected file server. Which of the following items should the administrator consider to determine the cause of this corruption?()
第5题:
An administrator needs to maintain 1TB of storage space for a server. A performance critical application will use this storage space for a database. The database will be replicated between multiple servers. Cost and performance are the most important considerations. Which of the following RAID configurations would be the BEST choice for the storage array?()
第6题:
A high availability solution must be designed for a single file server. Data must be replicated between the disks to ensure a failure of one disk does not bring down the server. Which of thefollowing meets these requirements?()
第7题:
An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem?()
第8题:
A system administrator needs to maintain 1.2TB of storage for a database server. There are six 250GB drives available in the server for storage space. Which of the following RAID configurations would be the BEST choice given that performance and fault tolerance are important factors?()
A. RAID 1 across drive pairs totaling 3 pairs
B. RAID 5 across all 6 drives
C. RAID 10 across all 6 drives
D. RAID 0 across all 6 drives
第9题:
A system administrator needs to maintain 1.2TB of storage for a database server. There are six 250GB drives available in the server for storage space. Which of the following RAID configurations would be the BEST choice given that performance and fault tolerance are important factors?()
第10题:
An administrator is configuring one server to monitor hardware level information on a second Windows server. Which of the following should be setup on the Windows server to allow the monitoring server to access this information? ()