An administrator is experiencing availability issues on a Linux server. The administrator decides tocheck the server for an IP address conflict on the server. Which of the following commands should the administrator use?()
第1题:
The network administrator has just finished installing a new 10/100/1000 switch, but receives reports from the server administrator that servers connected to the new switch seem to be experiencing slow LAN connections. The network administrator checks the port connecting the new switch to the core switch and sees the following information:Which of the following is the MOST likely cause of the slow connections?()
A. The servers have not had VLAN tagging enabled on their NICs.
B. Speed and duplex have not been set.
C. VLAN tagging was not set on the trunk.
D. The servers have been connected with CAT5 cable.
第2题:
A. Escalating the problem
B. Testing the solution and identifying the effects
C. Continuing to gather information about the same symptoms
D. Documenting the solution and the entire process
第3题:
(ii) Explain the ethical tensions between these roles that Anne is now experiencing. (4 marks)
第4题:
Windows默认帐户应如何管理()
第5题:
Users have been complaining that their Frame Relay connection to the corporate site is very slow. The network administrator suspects that the link is overloaded. Based on the partial output of the Router show frame relay pvc command shown in the graphic, which output value indicates to the local router that traffic sent to the corporate site is experiencing congestion?()
A. DLCI = 100
B. last time PVC status changed 00:25:40
C. in BECN packets 192
D. in FECN packets 147
E. in DE packets 0
第6题:
An administrator is experiencing availability issues on a Linux server. The administrator decides tocheck the server for an IP address conflict on the server. Which of the following commands should the administrator use?()
A.traceroute
B.tracert
C.ifconfig
D.ipconfig
第7题:
A system is experiencing packet routing problems,when the administrator runs ‘netstat -nr‘ the following default routes are displayed: default165.253.251.1UG51601304 en8--default 192.168.50.1UGH01590450 en4-- Assuming the first route is correct.How can the administrator remove the incorrect default route?()
A.route delete default 192.168.50.1
B.access smit with the route_remove shortcut
C.chdev -l inet0 -a delroute=net,-hopcount,0,,192.168.50.1
D.flush the routing table from the console and configuring the 165.253.251.1 route
第8题:
A.mark
B.color
C.filter
D.discard
第9题:
While troubleshooting a connectivity problem, a network administrator notices that a port status LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this indicate?()
第10题:
An administrator attempts to install the latest security patches for an older server. When the administrator runs the patch installer, the install fails. The administrator tries again, and the installer fails again. Which of the following is the MOST likely reason for this?()