Companycom is moving their application to a p5 590 and at th

第1题：

Companycom is buying an application solution that bases its software licensing on the number of CPUs per machine. They will be running two instances of this application and will require 8 CPUs each. A second application is priced based on CPUs per LPAR as well as the class of machine. That application will require 8 CPUs. What is the best hardware to propose to keep the software cost low?（）

• A、A 24 way p5 595 with 3 LPARs
• B、A 24 way p5 595 with 2 LPARs
• C、One p5 570s 16 way and one p5 570 8 way
• D、One p5 595 12 way active and 12 way inactive， and one p5 570 8 way

第2题：

Companycom is considering a partitioned solution which will require cumulative rPerf total of 150. The original sizing came back recommending a 32-way p5 590. However, they have a requirement for future scalability and availability is important. Which of the following would be the best reason to recommend a p5 595?（）

• A、The p5 595 would allow for COD
• B、The p5 595 includes the Advanced Power Virtualization hardware and software
• C、The p5 595 is priced the same as the p5 590 given the same number/type of CPUs
• D、The p5 595 performance would be equivalent to the p5 590 given the same number/type of CPUs

第3题：

For the p5 590 and p5 595 servers, the HMC must be directly attached. Why is the use of a private service network between HMC and the p5 590 required?（）

• A、The Bulk Power Controllers are dependent upon the HMC to provide them with DHCP  addresses.
• B、A firewall is required to isolate the private network from any of the open networks to which the HMC is attached.
• C、Network communications can be implemented through an open network. No private network  is required but it is recommended.
• D、All p5 590 and 595 servers are shipped with one service processor card. A private network is  required to manage DHCP addresses.

第4题：

Companycom is migrating their application that was built on AIX 4.3, to a new p5 590 system that is running AIX 5.3. The application was a 32-bit program. What will need to be done with the application to allow it to run on the new system?（）

• A、Run without recompiling on AIX 5.3
• B、Relink to the 32-bit kernel in order to run the application
• C、Recompile to run on AIX 5.3 because the libraries are in different locations
• D、Recompile 32-bit applications because the compiler flags and versions have changed

第5题：

Companycom is currently using a p690 and has just ordered a p5 590. They prefer to run in full system partition mode, since their application will utilize all the resources in the machine, and they don't want the overhead of an LPAR. What is the best response to the customer about the POWER5 capabilities?（）

• A、POWER5 runs in an SMP mode as default
• B、POWER5 can run in a full system mode the same as the p690
• C、POWER5 can run in full system mode with the purchase of PLM
• D、POWER5 can run in a full system mode， but it is in LPAR mode

第6题：

Companycom is installing a p5 590 with a HMC to manage LPARs. The customer is very concerned about security and wants to restrict network traffic that is not necessary. What is necessary for communication between the LPARs and the HMC?（）

• A、An administrative VLAN with port 1808
• B、Port 657 which must remain open to TCP/IP and UDP traffic
• C、Network addresses are provided by DHCP services on the network
• D、DHCP on the HMC is required to be on to communicate between LPAR and HMC

第7题：

Companycom has just added some new disk drives to a p5 590. The customer needs to know the largest Logical Track Group that these drives will support. What is the best way to locate this information?（）

• A、Use lquerypv to read the drive
• B、Use lspv and look at PP Size value
• C、Look on the outside of the drive itself
• D、Use bootinfo to find the LTG on the drive

第8题：

Companycom has a requirement to consolidate six web application servers. There is unused capacity of 2 CPUs on their new p5 570. Which operating systems and or features are required?（）

• A、APV, AIX5.2ML4
• B、AIX5.3 or i5/OS
• C、APV, i5/OS, AIX5.3
• D、APV, AIX5.3 or SuSE9

第9题：

A system administrator is installing a p5 590 server with an HMC. After pulling the websm client down, it is not possible to connect to the HMC. The HMC can be pinged from the client. Which of the following settings should be verified next?（）

• A、The routes on the HMC
• B、The firewall setting of the LAN adapter
• C、The name resolution protocol on the p5 590 server
• D、The subnet mask settings on the Ethernet adapters

第10题：

Companycom has a p690 server with unused fiber (HBA) host bus adapters (feature code 6228) that they would like to reuse. They are interested in implementing Advanced Power Virtualization features particularly Virtual IO. What is the best way to proceed?（）

• A、Upgrade the p690 to a p5 590 server running AIX 5.3
• B、Upgrade the p690 server to AIX 5.3 and implement Advanced Power Virtualization
• C、Purchase a p5 590 with minimum resources and simply reuse the p690 unused fiber HBA adapters
• D、Purchase a p5 590 that has all the needed resources and adapters for Advanced Power Virtualization