A technician is replacing memory in a server whose motherboa

第1题：

A server technician has been attempting to install an operating system on the company test server for several days. The technician has experienced error messages at several points of theinstallation and the system has frozen during various parts of the boot process. The technician has replaced the power supply， graphics card and installation disk with known good components.Which of the following could be causing these issues？（）

• A、Storage driver not loaded
• B、Fragmented hard drive
• C、Damaged or faulty NIC chipset
• D、Damaged or faulty system board
• E、Memory incompatible with the processor
• F、Missing voltage regulator

第2题：

A technician is installing new memory in a server. The technician would consult the HCL to ensure which of the following？（）

• A、Memory and virtual memory compatibility
• B、Memory and speed compatibility
• C、Memory and HDD compatibility
• D、ESD standards were followed

第3题：

Memory was recently taken out of a fully functional production server before it wasdecommissioned and added to another server.  Upon booting up the server with the additional memory the server emits a series of beeps and fails to POST.  Which of the following is MOST likely the problem？（）

• A、Incompatible memory
• B、Memory failure
• C、The memory is not configured
• D、The server BIOS was not configured to accept the additional memory

第4题：

When replacing a laptop keyboard, the FIRST thing that Bob, a technician, should do is remove:（）

• A、the battery.
• B、the memory cover and memory sticks giving access to the screws holding the keyboard in place.
• C、the top bezel covering the screws holding the keyboard in place.
• D、the AC power.

第5题：

The technician is repairing a PC which appears to have a failing RAM module. After replacing the module, the extra memory still is not registering. Which of the following is MOST likely the issue?（）

• A、Jumper settings are incorrect
• B、The RAM module is defective
• C、The memory slot is defective
• D、CMOS needs to be flashed

第6题：

A technician has to populate a server motherboard with memory. The board has a memory bus speed of 800 MHz. Which of the following memory types should be used？（）

• A、DDR3
• B、SDRAM
• C、DDR
• D、DDR2

第7题：

An administrator is upgrading memory on the server. Once the server in turned back on， the administrator notices that the memory has not changed. The system board website says the board should accept the new amount of memory.  Which of the following should the administrator do FIRST？（）

• A、 Replace memory chips with known good memory chips.
• B、 Reseat the memory chips.
• C、 Update the BIOS.
• D、 Upgrade the server OS.

第8题：

An administrator is adding additional memory into a server that registers 1GB of memory in the OS and notices that the system has 2GB of memory physically installed； however， the server only shows 1GB of memory during POST.  Which of the following is the MOST likely reason for this？（）

• A、 The OS does not support more than 1GB of memory.
• B、 The system memory has different manufacture dates.
• C、 Two of the memory sticks are defective.
• D、 The server is using memory interleaving.

第9题：

When replacing a power supply， what MUST the technician observe？（）

• A、voltage
• B、current
• C、wattage
• D、resistance

第10题：

A technician is replacing memory in a server whose motherboard supports PC3-8500 memory.  This type of memory is also known as which of the following？（）

• A、SDRAM
• B、DDR
• C、DDR3
• D、DDR2