Routers A and B have an OC12c and a GE link between them and are running OSPF over both ofthese links. Which statement is correct, assuming the default JUNOS software OSPF metric calculation?()
第1题:
Refer to the exhibit. Router B and router C are performing mutual redistribution between OSPF and EIGRP, and their default metrics are configured the same. Router D has equal cost paths to networks where both paths are not r eally equal cost. For example, network 172.16.54.0 shows equal cost through both router B and router C, though in reality the cost is greater using router C. Other routers, though not shown, are connected to the 172.16.54.0 and 172.16.55.0 networks, and the same issues exist to those routers and the networks connected to them. What can be done so that data will be routed along the most optimal path in the network? ()
A. Redistribute connected interfaces on router B and router C
B. Set the maximum nu mber of equal cost paths to1 in all routers
C. When redistributing EIGRP into OSPF, set the external metric type to type E1
D. Adjust the default metrics in router B and router C so that the values are different in each router
E. None of these solut ions will fix the problem. Migrate to a single dynamic routing protocol
第2题:
第3题:
A. Takes the metric of the outgoing interface.
B. Uses the metric that is assigned during configuration.
C. Uses the path metric to reach the virtual link neighbor.
D. Uses a default of zero unless otherwise specified.
第4题:
You have two EBGP peers connected via two parallel serial lines. What should you do to be able to load-balance between two EBGP speakers over the parallel serial lines in both directions? ()
第5题:
Which statement is correct about an OSPF sham-link?()
第6题:
A.If RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.
B.If RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
C.If EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.
D.If EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
E.If EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.
F.If EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.
第7题:
If the OSPF protocol is used to connect customer edge (CE) routers to service provider edge(PE) routers in the VPN backbone, which two options best describe the use of SHAM links?()
第8题:
A.0
B.1
C.2
D.3
第9题:
When verifying OSPF virtual link problems, which is an important item to check on the two transit OSPF routers?()
第10题:
Which two statements are correct regarding default protocol preference values?()