Which of the following will occur if a laptop SATA 1 drive is installed on a SATA 2 controller?（）
第1题：
A. Format the partition
B. Load any RAID or SATA drivers needed
C. Partition the drive
D. Configure Windows settings
第2题：
You have two servers named Server1 and Server2 that run Windows Server 2003 Service Pack (SP2).You connect a USB drive to Server1 and copy several files to the USB drive.You connect the USB drive to Server2. You receive a message that the drive installed successful and isready-to-use.You open Windows Explorer and the USB drive does not appear.You need to ensure that you can access the files stored on the USB drive.What should you do? （）
A. From the command prompt, run Convert.exe.
B. From the Disk Management snap-in, change the drive letter.
C. From the Services snap-in, restart the Removable Storage service.
D. From the Device Manager snap-in, scan for a hardware change.
第3题：
A. Use a jumper from the motherboard where the new drive is going to be installed.
B. Use a jumper from a hard drive that is no longer functioning.
C. Contact the manufacturer of the new hard drive and have a replacement jumper shipped immediately.
D. The new hard drive must be replaced
第4题：
Which of the following steps would be performed FIRST to install a fresh copy of Windows 7Professional on a new hard drive?（）
第5题：
A client purchased a new internal hard drive to act as a second drive on a legacy machine. When the client attempts to install the drive, the cable connector on the new drive is not compatible with the available IDE cables. It is determined that the client has purchased a SATA hard drive. Which of the following would the technician recommend as the BEST solution to this situation?（）
第6题：
A. Compact flash drive
B. SATA hard drive
C. Blu-Ray drive
D. SDLT Tape drive
第7题：
A technician has lost a necessary jumper for a new hard drive that must be installed immediately.Which of the following is the BEST solution?（）
第8题：
A Windows 2003 Server is no longer able to access its internal SCSI drive. The cables are connected, the drive has power, and the drive shows up in Device Manager; however, the My Computer window does not show the drive that was previously working and formatted with NTFS.Which of the following would be the FIRST step in regaining access to the drive?（）
A. Reformat the NTFS partition.
B. Recreate the partition that was deleted.
C. Rewrite the MBR.
D. Run a check disk on the drive
第9题：
A user installed a Blu-Ray drive in their PC. The user reports that the new drive and their existing DVD-RW drive are not operating. Which of the following needs to be replaced?（）
第10题：
An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）