Company.com has an application that requires a serial connection for Electronic Data Interchange. What must be done to integrator the serial connection into an HACMP cluster?()
第1题:
A. Nothing. The router is already suitable.
B. A BRI WAN interface in the router.
C. An external NT1 to terminate the local loop.
D. A TA/NT1 device on the router.
第2题:
You have just obtained a modular Cisco router with 2 serial connections and a BRI/U interface. What other physical piece of hardware is required in order to establish an ISDN connection?()
第3题:
A.Twenty-Five
B.Forty
C.Sixteen
D.Seven
第4题:
A two-node cluster is attached via SAN to shared disk. The customer has requested that one of the nodes be moved to another room 300 feet away. However, this distance exceeds the length specified by the RS232 specifications. What solution would resolve the RS232 specification issue with the fewest additional components?()
第5题:
While logged into a router you manually shut down the serial 0 interface using the "shutdown" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be?()
第6题:
A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router.How should the network administrator configure the serial interface of the main office router to make the connection?()
A.
B.
C.
D.
第7题:
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? ()
第8题:
A. TE1
B. TE2
C. TA
D. NT1
E. NT2
第9题:
Company.com wishes to use HACMP on two IBM eServer pSeries servers. During the planning session, it was decided to use the native serial ports s1 or s2 for a non-IP heartbeat network. What should be done to ensure the serial network will function with HACMP heartbeats?()
第10题:
Company.com with a newly installed cluster has been checking the logfiles to determine if the cluster has had any recent activity. The non-IP RS232 heartbeat connection seems to be having a difficulty. The serial network goes down,and then a couple of minutes later comes back up again. This pattern is repeated many times in the log. If this system was installed without regard to best practices, what is the most likely problem with the serial network?()