A Cisco router has been configured with the following command:IP nat pool nat-test 192.168.6.10 192.168.6.20 netmask 255.255.255.0his is an example of what type of NAT?（）
第1题：
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
A. Stateful Switchover for Cisco Nonstop Forwarding only works with BGP.
B. Stateful Switchover for Cisco Nonstop Forwarding must be configured on all adjacent routers.
C. Cisco Nonstop Forwarding with Stateful Switchover helper mode is not supported on the adjacent router.
D. Cisco Nonstop Forwarding with Stateful Switchover helper mode for OSPF has been promiscuousstandardized and is supported on the adjacent router.
第2题：
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines.What command would assign this access- list to the Virtual Terminal Lines?（）
A. router(config-line)# ip access-group 1 in
B. router(config-line)# access-class 1 in
C. router(config-line)# ip access-list 1 in
D. router(config-line)# access-line 1 in
第3题：
A.A
B.B
C.C
D.D
第4题：
Cisco Express Forwarding has been enabled on router TK1. With CEF， prefixes that require exception processing can be cached with one of which four special adjacencies？ （）
第5题：
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）
A. one
B. three
C. two
D. zero
第6题：
A. R4(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
B. R4(config)# ip default - network 10.0.0.0
C. R4(config - router)# default -information originate
D. R4(conf ig)# ip route 10.0.0.0 255.0.0.0 10.1.1.1
第7题：
A. Static NAT
B. Dynamic NAT
C. Dynamic NAT with overload
D. Port Address Translation
E. None of the above
第8题：
How can a Ezonexam administrator determine if a router has been configured when it is first powered up?
A．A configured router prompts for a password
B．A configured router goes to the privileged mode prompt
C．An un configured router goes into the setup dialog
D．An un configured router goes to the enable mode prompt
第9题：
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
第10题：
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）