An 802.1Q trunk is not coming up between two switches. The ports on both switches are configured as "switchport mode desirable." Assuming that there is no physical issue, choose two possible causes.()
第1题:
You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)
A. Switch(vlan) mode trunk
B. Switch(config) switchport access mode trunk
C. Switch(config-if) switchport mode trunk
D. Switch(config-if) switchport trunk encapsulation dot1q
E. Switch(config) switchport access mode 1
F. Switch(vlan) trunk encapsulation dot1q
第2题:
一台Cise0交换机和一台3COM交换机相连,相连端口都工作在VLAN trunk模式,这两个端口应使用的VLAN协议是( )。
A.ISL和IEEE 802.10
B.ISL和ISL
C.ISL和IEEE 802.1Q
D.IEEE 802.1Q和IEEE 802.1Q
第3题:
Cisco Catalyst 6500交换机的3/1端口与一台其他厂商的交换机相连,并要求该端口工作在VLANTrunk模式。这两台交换机的Trunk端口都应封装的协议和Cisco Catalyst 6500设置Traank模式的正确配置语句分别是______。
A.ISL和set 3/1 trunk on isl
B.ISL和set trunk 3/1 on isl
C.IEEE 802.1Q和set tramk 3/1 on dotlq
D.IEEE 802.1Q和set 3/1 trunk on dotlq
第4题:
当VLAN数据帧通过trunk链路转发时,将会在以太网帧中加入802.1Q标记,以区分不同VLAN的数据帧。该标记插入到了原始以太网帧的()
第5题:
A.VLAN聚合技术
B.TRUNK技术
C.端口聚合技术
D.HGMP技术
第6题:
What must the Ezonexam network administrator do in order to successfully configure a VLAN trunk between two switches named VE1 and VE2? (Select two answer choices)
A. Set each end of the trunk line to IEEE 802.1Q encapsulation.
B. Set the same VTP management domain name on both switches.
C. Set all ports on the two switched as access ports.
D. Configure one of the two switches as a VTP server.
E. Connect the two switches using a rollover cable.
F. Use a router to forward VTP traffic between the VLANs.
第7题:
A. Set each end of the trunk line to IEEE 802.1Q encapsulation.
B. Set the same VTP management domain name on both switches.
C. Set all ports on the two switched as access ports.
D. Configure one of the two switches as a VTP server.
E. Connect the two switches using a rollover cable.
F. Use a router to forward VTP traffic between the VLANs.
第8题:
一台Cisco交换机和一台3COM交换机相连,相连端口都工作在Ⅵ,AN trunk模式,这两个端口应使用的VLAN协议是——。
A.ISL和IEEE 802.10
B.ISL和ISL
C.ISL和IEEE 802.1Q
D.IEEE 802.1Q和IEEE 802.1Q
第9题:
Which statements about 802.1Q trunking in Secure Network Foundation Design Guide for Single Site Deployments are correct?()
第10题:
当VLAN数据帧通过trunk链路转发时,将会在以太网帧中加入802.1Q标记,以区分不同VLAN的数据帧。在802.1Q标记中,VLAN字段的最大可能值是()