set protocols rsvp cspf-enable
set protocols mpls cspf-enable
set protocols rsvp traffic-engineering
set protocols ospf traffic-engineering
第1题:
A. set protocols bgp group mygroup path-selection cisco-non-deterministic;
B. set protocols bgp group i-bgp no-aggregator-id;
C. set protocols bgp group mygroup no-client-reflect;
D. set protocols bgp group i-bgp damping;
第2题:
A. set protocols ospf import static-routes
B. set protocols ospf export static-routes
C. set routing-options static defaults readvertise
D. set routing-options static route 0.0.0.0/0 readvertise
第3题:
A. set protocols isis inet6
B. set routing-options router-id router-id
C. set protocols ospf3 area 0 interface all
D. set interface fe-0/0/1 unit 0 family inet6
E. set routing-options ipv6-router-id router-id
第4题:
Which two commands would change the default OSPF metric calculation for interface ge-0/3/0 in JUNOS software?()
第5题:
You wish to configure IPv6 support on a router which does not have any current IPv4 configuration.Which three steps are used to configure IPv6 with an accompanying IGP in JUNOS software? ()
第6题:
A. set protocols rsvp cspf-enable
B. set protocols mpls cspf-enable
C. set protocols rsvp traffic-engineering
D. set protocols ospf traffic-engineering
第7题:
A.edit policy-options policy-statement policy-name set term 1 from protocol static set term 1 then accept
B.edit ospf policy set from protocol static set 1 then accept
C.set protocols OSPF export policy-name
D.set protocols OSPF policy policy-name
第8题:
A. set protocols ospf area-range network/mask-length
B. set protocols ospf area area-id nssa area-range network/mask-length
C. set protocols ospf area area-id area-range network/mask-length restrict
D. set protocols ospf area area-id nssa area-range network/mask-length restrict
第9题:
In MPLS traffic engineering, which one of the following protocols is used for Path Setup?()
第10题:
Which command will apply a policy to redistribute static routes into OSPF?()