Choose the lowest primary address.
If assigned, always choose address of fxp0.
Choose numerically lowest IP address of fxp0.
Choose the non-127.0.0.1 primary address on lo0.
第1题:
A. The IP address can be automatically assigned to a host.
B. The IP address can be assigned as a random hash value of the burned - in - address of the lowest - numbered LAN interface on the router.
C. The network administrator can assign a speci fic IP address to a specific host MAC address.
D. The IP address can be assigned from configured pools in a reverse lexicographical order.
E. The IP address can be assigned to a host for a limited time or until the host explicitly releases the address.
F. The IP address can be assigned to a host until the host usurps the assigned value using its own dynamic override mechanism.
第2题:
A. the IP address of the first Fast Ethernet interface
B. the IP address of the console management interface
C. the highest IP address among its active interfaces
D. the lowest IP address among its active interfaces
E. the priority value until a loopback interface is configured
第3题:
A. Manually assign rid.
B. configure local-address.
C. enable the fxp0 interface.
D. Assign nonmartian address to lo0.
第4题:
In which two ways can the router ID selection be controlled?()
第5题:
In JUNOS software, what is the purpose of the eui-64 command?()
第6题:
A. The IP address of the first Fast Ethernet interface.
B. The IP address of the console management interface.
C. The highest IP address among its active interfaces.
D. The lowest IP address among its active interfaces.
E. There will be no router ID until a loopback interface is configured.
第7题:
The PPP over Ethernet Discovery Stage determines which two parameters? ()(Choose two.)
第8题:
A. When Area 0 is active, the loopback interface must be configured in OSPF for it to be advertised.
B. When Area 0 is active, the loopback address is automatically advertised into other areas.
C. When Area 0 is active, the OSPF router-id must match the loopback address for the loopback address to be advertised.
D. When Area 0 is active, the router-id must be configured for the loopback address to be advertised.
第9题:
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
第10题:
In which two ways can the router ID selection be controlled?()