set interfaces fe-0/0/0 address 10.1.1.1/24
set interfaces fe-0/0/0.0 family inet address 10.1.1.1/24
set interfaces fe-0/0/0.0 address 10.1.1.1/24
set interfaces fe-0/0/0 unit 0 family inet address 10.1.1.1/24
第1题:
A. set interface fe-0/0/0.0
B. set interface fe-0/0/0.0 all level
C. set interface fe-0/0/0.0 level 3 enable
D. set interface fe-0/0/0.0 level 1 level 2
第2题:
A.set interfaces fe-0/0/0 unit 0 ethernet-options mtu 1200
B.set interfaces fe-0/0/0 mtu 1200
C.set interfaces fe-0/0/0 unit 0 mtu 1200
D.set interfaces fe-0/0/0.0 mtu 1200
第3题:
A. set security zones management interfaces ge-0/0/0.0
B. set zones functional-zone management interfaces ge-0/0/0.0
C. set security zones functional-zone management interfaces ge-0/0/0.0
D. set security zones functional-zone out-of-band interfaces ge-0/0/0.0
第4题:
PC连接在交换机SWA的端口E1/0/2,IP地址为10.1.1.1,MAC地址为0-01-02-01-21-23。为了保证网络安全,需要在端口E1/0/2上配置MAC+IP+端口绑定。则下列哪个命令是正确的?()
第5题:
A network administrator wants to verify the active alarms on interface so-0/0/0.0. Which command displays this information?()
第6题:
A.set interfaces fe-0/0/0 address 10.1.1.1/24
B.set interfaces fe-0/0/0.0 family inet address 10.1.1.1/24
C.set interfaces fe-0/0/0.0 address 10.1.1.1/24
D.set interfaces fe-0/0/0 unit 0 family inet address 10.1.1.1/24
第7题:
A. The IP address of the first Fast Ethernet interface.
B. The IP address of the console management interface.
C. The highest IP address among its active interfaces.
D. The lowest IP address among its active interfaces.
E. There will be no router ID until a loopback interface is configured.
第8题:
An administrator is unable to ping any address on the 10.0.19.0/24 subnet. To identify the problem, the administrator uses the command shown in the exhibit.Which step should be taken to solve the problem?()
A. Check the physical cable.
B. Issue the command activate interfaces fe-0/0/1.5 .
C. Issue the command delete interfaces fe-0/0/1.5 disable.
D. Reconfigure the IP address.
第9题:
Which command is a valid way to view the status of an interface?()
第10题:
You accidentally configured interface so-0/0/0.0 with /32 instead of /30. Which two solutions could you use to correct this configuration?()