If it is properly deployed，a controller-based access point i

第1题：

Which of the following statements explains why it is normally best to have more than one controller-basedaccess point participate in the containment of one rogue access point？（）

• A、Multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
• B、Clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
• C、Each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
• D、Clients connected to the rogue access point must be able to connect to the containment controller-based access point.

第2题：

If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）

• A、Monitor
• B、Rogue Detector
• C、Sniffer
• D、Mirror

第3题：

On a Cisco 1000 Series controller-based access point， the alarm LED is flashing red， but the otherLEDs are off. What is this access point indicating？（）

• A、Its IP address already exists.
• B、It is operating normally.
• C、It requires a code upgrade.
• D、It has lost contact with the controller.

第4题：

You are installing a cisco aironet 1000 series controller-based access point. when you boot it， all the leds on the access point blink together. What does this indicate about the access point？（）

• A、duplicate ip address
• B、code upgrade in progress
• C、normal operation
• D、searching for primary controller

第5题：

In order for a controller-based access point to be allowed to participate in aggressive load balancing，it must have heard the client within how many seconds？（）

• A、15
• B、10
• C、1
• D、5

第6题：

If it is properly deployed，a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu on thecontroller？（）

• A、Mirror
• B、Rogue Detector
• C、Sniffer
• D、Monitor

第7题：

A Cisco Aironet 1020 controller-based access point has been connected to a Catalyst 3550-24PWR Switch. However， when it is powered up， the access point fails. What has caused this problem？（）

• A、access point does not support 802.11h
• B、incorrect switch power supply
• C、switch port is not enabled
• D、switch does not support 802.3af
• E、access point has not been initialized with the primary controller

第8题：

The Cisco 521 Wireless Express Access Point used in the Smart Business Communications System can be configured to operate in which mode?（）

• A、controller-based mode only
• B、either standalone mode or controller-based mode
• C、standalone mode only

第9题：

A Cisco Aironet 1020 controller-based access point has been connected to a Catalyst 3550-24 PWRSwitch. However， when it is powered up， the access point fails. What has caused this problem？（）

• A、access point does not support 802.11h
• B、incorrect switch power supply
• C、switch port is not enabled
• D、switch does not support 802.3af
• E、access point has not been initialized with the primary controller

第10题：

In order for a controller-based access point to be allowed to participate in aggressive loadbalancing，it must have heard the client within how many seconds？（）

• A、15
• B、10
• C、1
• D、5