Router R1 is redistributing between two OSPF processes. Give

题目
单选题
Router R1 is redistributing between two OSPF processes. Given the configuration shown, which includes all commands in the route map named fred, which of the following answers is true regarding the redistribution into OSPF process 1?() router ospf 1 redistribute ospf 2 external 2 route - map fred ! route - map fred permit 10 match ip address 1 set metric - type type - 1
A

No routes are redistributed because a route cannot be both E1 and E2.

B

Only OSPF E2 routes in the OSPF 2 domain will be considered for redistribution.

C

Inside the OSPF 2 domain, any formerly E2 routes will become E1 routes.

D

Routes permitted by ACL 1 will be redistributed, regardless of whether the routes are E1 or E2 routes.

如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

On Router R1, process EIGRP 1 is redistributing routes from process OSPF 2, calling route - map fred with the redistribute ospf 2 command. R1 has learned intra - area routes for 10.1.1.0/24 and10.1.2.0/24 in part due to the Type 2 LSAs known for each subnet. The route map filters route 10.1.1.0/24 and allows 10.1.2.0/24 througH.Which of the following co mmands on router R1 list subnet 10.1.1.0/24?()

A. show ip route

B. show ip eigrp topology

C. show ip ospf topology

D. show ip eigrp topology 10.1.1.0/24


参考答案:A, C

第2题:

You have completed an OSPF implementation, and you are verifying OSPF operation. During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly appearing and disappearing from the routing table. Further investigation finds that the OSPF CPU utilization is very high and the routers are constantly performing SPF calculations. You determine that 172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf database router 172.16.20.1 command, you notice that when this show command is performed repeatedly, the contents of the LSA change every few seconds.What could be the cause of this problem?()

A. OSPF authentication errors between some of the routers

B. Two routers have the same OSPF router ID

C. Issues with mistuned OSPF timers

D. OSPF LSA pacing issues between some of the routers

E. OSPF neighbor adjacency problems between some of the routers


参考答案:B

第3题:

What type of OSPF router is responsible for redistributing routes into OSPF?()

A. ABR

B. ASBR

C. internal router

D. backbone router


参考答案:B

第4题:

You have completed an OSPF implementation, and you are verifying OSPF operation. During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly appearing and disappearing from the routing table. Further investigation finds that the OSPF CPU utilization is very high and the routers are constantly performing SPF calculations. You determine that 172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf database router 172.16.20.1 command, you notice that when this show command is performed repeatedly, the contents of the LSA change every few seconds. What could be the cause of this problem?()

  • A、OSPF authentication errors between some of the routers
  • B、Two routers have the same OSPF router ID
  • C、Issues with mistuned OSPF timers
  • D、OSPF LSA pacing issues between some of the routers
  • E、OSPF neighbor adjacency problems between some of the routers

正确答案:B

第5题:

Enterprise Router R1, in ASN 1, connects to ISP Router I1, ASN 2, using eBGP. There are two parallel serial links between the two rou ters. The implementation plan calls for each router to base their BGP TCP connection on their respective loopback1 interfaces, with IP addresses 1.1.1.1 and 2.2.2.2, respectively. Which of the following commands would not be part of a working eBGP confi guration on Router R1?()

  • A、router bgp 1
  • B、neighbor 2.2.2.2 remote- as 2
  • C、neighbor 2.2.2.2 update - source loopback1
  • D、neighbor 2.2.2.2 multihop 2

正确答案:D

第6题:

Router R1 refers to route - map fred when redistributing from EIGRP into OSPF. The entire route - map is listed next. Which of the following answers must be true based on the configuration as shown?()route - map fred deny 10match ip address oneroute - map fred deny 20match ip address tworoute - map fred permit 100

A. The third route map clause will allow any routes not already filtered by the first two clauses

B. R outes permitted by ACL "two" will be redistributed

C. Routes denied by ACL "one" will be redistributed

D. All routes will be filtereD


参考答案:A

第7题:

Refer to the exhibit. OSPF is configured on all routers in the network. On the basis of the show ip ospf n eighbor output, what prevents R1 from establishing a full adjacency with R2? ()

A. Router R1 will only establish full adjacency with the DR and BDR on broadcast multi- access networks.

B. Router R2 has been elected as a DR for the broadcast multiaccess network in OSPF area 1.

C. Routers R1 and R2 are configured as stub routers for OSPF area 1 and OSPF area 2.

D. Router R1 and R2 are configured for a virtual link between OSPF area 1 and OSPF area 2.

E. The Hello parameters on routers R1 and R2 do not m atch.


参考答案:A

第8题:

Router R1 sets a route tag for subnet 10.1.1.0/24 when redistributing from OSPF into EIGRP.Which of the following unit is assigned to the route tag?()

A. Kilobits/seconD

B. Tens of microseconds

C. Cost

D. Hop count

E. No unit is assigneD


参考答案:E

第9题:

A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router,as the routing protocol for the network.Which statement about thisnetwork is true?()

  • A、For the two vlans to communicate,a network statement for the trunk interface needs to be added to the  OSPF configuration.
  • B、For the two vlans to communicate, a network statement for each subinterface needs to be  added  to the OSPF configuration.
  • C、Direct inter-vlan communication does not require OSPF
  • D、OSPF cannot be used if router-on-a-stick is configured on the router

正确答案:C

第10题:

Router R1, an ASBR connected to the Internet and to backbone area 0, has been configured with a default - information originate command. Which of the following is true about the effects of this configuration command?()

  • A、R1 will always create and flood a default route into the OSPF domain.
  • B、R1 will create and flood an LSA for prefix/length 0.0. 0.0/0 into the OSPF domain if R1's IP routing table has a route to 0.0.0.0/0.
  • C、R1 will set a flag on the LSA for the subnet between itself and one of the ISPs, noting this subnet as a default network, regardless of whether R1 has a default route.
  • D、R1 w ill set a flag on the LSA for the subnet between itself and one of the ISPs, noting this subnet as a default network, but only if R1 has a route to 0.0.0.0/0.

正确答案:B

更多相关问题