Provides local hosts with a default gateway address
Allows remote management of the switch.
Allows the switch to respond to ARP requests between two hosts
Ensures that hosts on the same LAN can communicate with each other.
第1题:
You need to perform. some initial configuration tasks on a new Ezonexam switch. What is the purpose of assigning an IP address to a switch?
A.To provide local hosts with a default gateway address
B.To allow remote management of the switch.
C.To allow the switch to respond to ARP requests between two hosts
D.To ensure that hosts on the same LAN can communicate with each other.
E.None of the above
第2题:
A. source MAC address
B. source IP address
C. source switch port
D. destination IP address
E. destination port address
F. destination MAC address
第3题:
A.Switch(config)#ip address 192.168.1.1
B.Switch(config-if)#ip address 192.168.1.1
C.Switch(config-if)#ip address 192.168.1.1 255.255.255.0
D.Switch(config-if)#ip address 192.168.1.1 netmask 255.255.255.0
第4题:
Inverse ARP is being used in the TestKing frame relay network. What is the purpose of Inverse ARP?()
第5题:
What is the purpose of the inverse ARP?()
第6题:
A. To ma a known IP address to a MAC address
B. To map a known DLCI to a MAC address
C. To ma a known MAC address to an IP address
D. To ma a known DLCI address to a IP address
E. To ma a known IP address to a SPID address
F. To ma a known SPID address to a MAC address
第7题:
A.to map a known DLCI to an IP address
B.to mapa known IP address to a MAC address
C.to map known SPID toa MAC address
D.to map a known DLCI to a MAC address
E.to map a known IP address to a SPID
F.to mapa known MAC address to an IP address
第8题:
A.DHCP assigned addresses
B.RADIUS assigned addresses
C.IP numbered with a loopback reference
D.IP unnumbered with a loopback reference
第9题:
What is the purpose of the inverse ARP?()
第10题:
You work as a network Technician. A new workstation has consistently been unable to obtain anIP address from the DHCP server when the workstation boots. Older workstations function normally, and the new workstation obtains an address when manually forced to renew its address. What should be configured on the switch to allow the workstation to obtain an IP address at boot?()