nothing,BGP automatically load-balances the traffic between different autonomous systems on all available links
peer between the eBGP speaker’s loopbacks, configuring eBGP multihop as required, and use an IGP to load-share between the two equal-cost paths between the loopback addresses
configure a loopback as update source for both EBGP peers and have on each AS an IGP to introduce two equal-cost paths to reach the EBGP peer loopback address;it is also necessary to use the next-hop-self command
use the ebgp-load-balance command on the neighbor statement on both sides
configure a loopback as update source for both EBGP peers and have on each AS an IGP to introduce two equal-cost paths to reach the peer loopback address;it is also necessary to use the ebgp-multihop and next-hop-self commands
第1题:
A. EBGP peers advertise MED and change Next Hop.
B. EBGP peers advertise Local Preference and do NOT change Next Hop.
C. Confederation BGP peers advertise MED and do NOT change Next Hop.
D. Confederation BGP peers advertise Local Preference and change Next Hop.
第2题:
Two business partners have recently been connected via a dedicated extranet. It has been discovered that each of the companies are using the same private IP address space.Which of the following will help to resolve potential routing issues?()
A.Multicast
B.PAT
C.CIDR
D.NAT
第3题:
A. no BGP peers
B. all I-BGP peers
C. all E-BGP peers within your global AS
D. all E-BGP peers outside your global AS
第4题:
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state. Which two of these are possible causes? ()
第5题:
Two routers named Atlanta and Brevard are connected via their serial interfaces as illustrated, but they are unable to communicate. The Atlanta router is known to have the correct configuration.Given the partial configurations, identify the fault on the Brevard router that is causing the lack of connectivity?()
A.incompatible IP address
B.insufficient bandwidth
C.incorrect subnet mask
D.incompatible encapsulation
E.link reliability too low
F.IP/TCP closed
第6题:
A. IBGP peers
B. EBGP peers
C. active BGP peers
D. established BGP peers
第7题:
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state.Which two of these are possible causes? ()
A. Bandwidth statements do not match
B. MTUs do not match
C. IP Addresses are not in the same subnet
D. CHAP passwords do not match
第8题:
A. Peers are statically defined.
B. Peers exist within the same AS.
C. Peers must be directly connected to each other.
D. Peers advertise routes learned from other IBGP neighbors.
第9题:
In which of the following scenarios would the "show cdp neighbors detail"command be an appropriate troubleshooting tool?()
第10题:
Which two statements accurately describe an IBGP peering session?() (Choose two.)