increase the fuel oil temperature
decrease the fuel oil temperature
decrease the fuel oil supply pressure
increase the air supply
第1题:
The boiler water alkalinity in a coil-type auxiliary boiler should be maintained at the pH recommended by the boiler manufacturer to______.
A.precipitate(使沉淀) silica (硅石)from solution
B.reduce corrosion in the heating coil
C.prevent clogging and erosion in the coil
D.maintain zero water hardness
第2题:
cold fuel oil
low fuel oil pressure
low atomizing steam pressure
water in the fuel oil
第3题:
The correct procedure for giving an auxiliary boiler a bottom blow, is to begin .
A.when the boiler has been secured long enough for most solids to settle
B.when the boiler has been cooled to ambient temperature
C.only after raising the water level to within 0.5 inch of the high water cutout only
D.after bypassing the low pressure
第4题:
relight the boiler immediately to prevent loss of steam pressure
relight the fire off the brickwork as the bricks are cherry red
purge the furnace of any combustible gases before attempting to relight the fire
speed up the feed pump to prevent dry firing when the burner flame is reestablished
第5题:
will be modulated in proportion
will be modulated in proportion and integral
will be modulated in proportion and differential
will not be modulated at all
第6题:
When an auxiliary boiler is panting and emitting(发出) black smoke, you should______.
A.increase the fuel oil temperature
B.decrease the fuel oil temperature
C.decrease the fuel oil supply pressure
D.increase the air supply
第7题:
concentrations of calcium sulfate in the boiler water
fuel oil in the feed water
improper treatment of the feed water with calcium sulfate
excessive feed water alkalinity
第8题:
If the feed pump for an auxiliary boiler fails to deliver the feed water to the boiler, the cause may be ______.
A.high steam pressure in the boiler
B.abnormally high feed-water temperature
C.abnormally high boiler water temperature
D.steam demand exceeding feed pump capacity
第9题:
low water level
high water level
excessively high fuel pressure
low oil temperature
第10题:
operating the boiler at less than normal water level
installing fins on the firesides of water-tubes
increasing the amount of excess air to the burners
treating the boiler water with chemical oxygen scavengers