For proper operation, auxiliary boiler feed water must have

题目
单选题
For proper operation, auxiliary boiler feed water must have which of the following characteristics?()
A

High oxygen concentration

B

Low pH

C

Proper alkalinity

D

All of the above

如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

If the feed pump for an auxiliary boiler fails to deliver the feed water to the boiler, the cause may be ______.

A.high steam pressure in the boiler

B.abnormally high feed-water temperature

C.abnormally high boiler water temperature

D.steam demand exceeding feed pump capacity


正确答案:B

第2题:

辅助给水系统/应急给水系统 auxiliary feed water system/emergency feed water system


正确答案: 在蒸汽发生器主给水系统失效时,立即向蒸汽发生器供水的系统。也可作为反应堆启动、停堆时在主给水未投入的情况下向蒸汽发生器供水。

第3题:

The fuel supply system to an automatic auxiliary boiler, will be automatically shutdown if the boiler()

A.salinity is abnormally

B.high steam demand is too

C.feed-water flow is low

D.water level is abnormally low


答案:D

第4题:

单选题
In the event of a flame failure in an auxiliary water-tube boiler, you must()
A

relight the boiler immediately to prevent loss of steam pressure

B

relight the fire off the brickwork as the bricks are cherry red

C

purge the furnace of any combustible gases before attempting to relight the fire

D

speed up the feed pump to prevent dry firing when the burner flame is reestablished


正确答案: C
解析: 暂无解析

第5题:

单选题
The purpose of a temperature sensing device installed in the stack of a small automatically fired auxiliary steam boiler is to secure the oil burner()
A

in the event of a flame failure

B

in the event of a stack fire

C

when the water level reach the crown sheet

D

when the feed pump discharge pressure drops to a preset minimum


正确答案: D
解析: 暂无解析

第6题:

The boiler water alkalinity in a coil-type auxiliary boiler should be maintained at the pH recommended by the boiler manufacturer to______.

A.precipitate(使沉淀) silica (硅石)from solution

B.reduce corrosion in the heating coil

C.prevent clogging and erosion in the coil

D.maintain zero water hardness


正确答案:B

第7题:

单选题
The most common cause of scale formation in an auxiliary boiler is ()
A

concentrations of calcium sulfate in the boiler water

B

fuel oil in the feed water

C

improper treatment of the feed water with calcium sulfate

D

excessive feed water alkalinity


正确答案: C
解析: 暂无解析

第8题:

The water in an auxiliary boiler should be tested for chloride content to determine ( ).

A.total dissolved solids

B.salt contamination

C.water harcness

D.chlorine contamination


正确答案:B
解析:chloride:氯
译文:应对辅助锅炉的炉水进行含氯量化验,以判断其是否被海水污染。

第9题:

单选题
The purpose of the safety relief valves installed on an auxiliary boiler is to ().
A

relieve excess fuel oil pressure during the “off” fire cycle

B

admit water to the dry pipe

C

throttle the forced draft fan output for proper combustion

D

reduce excess steam pressure in the boiler


正确答案: C
解析: 暂无解析

第10题:

单选题
The rate of heat transfer in a water-tube auxiliary boiler can be increased by ().
A

operating the boiler at less than normal water level

B

installing fins on the firesides of water-tubes

C

increasing the amount of excess air to the burners

D

treating the boiler water with chemical oxygen scavengers


正确答案: B
解析: 暂无解析

更多相关问题