Hardware address takeover must be configured.
IPAT via IP aliasing is required for EtherChannel.
EtherChannel must be defined as a separate network.
HACMP does not support the fallover of EtherChannel.
第1题:
Please make the implementation as simple as possible. Only help functions and classes from
standard C&C++ may be used to aid your implementation.
第2题:
Users are reporting problems connecting to servers in the remote company.com domain. The administrator suspects this to be a DNS problem.Which of the following commands would the administrator run to identify the DNS server of the remote company.com?()
A. dig company.com ns
B. ipconfig/all
C. ifconfig-a
D. dig company.com mx
第3题:
● Project life cycles provide a better means of measurement of progress and control. The four phases of a project are conceptual development, _____, _____, and _____.
A Preliminary planning, detail planning, closeout
B Implementation, reporting, termination
C Development, implementation, termination
D Execution, reporting, finishing
E Implementation, termination, post-audit review
第4题:
Which two statements best describe EtherChannel?()
第5题:
第6题:
The stages within the development phase of the software life cycle are ( 71 ).
A.design, analysis, implementation, and testing
B.analysis, design, implementation, and testing
C.analysis, design, testing, and implementation
D.design, analysis, testing, and implementation
第7题:
A.VLANtrunking
B.Anexternalrouter
C.Aninternalrouteprocessor
D.VLANcapablebridge
E.EtherChannel
第8题:
YoudeployedaJavaEESharedLibraryandwanttouseitfromanapplicationthatisalsodeployedonthesamecluster.Whichtwomanifestattributesmustbespecifiedataminimumwithcorrespondingvaluesinthedeploymentdescriptoroftheapplicationthatrequires?()
A.Implementation-Version
B.Specification-Version
C.Extension-Name
D.Specification-Vendor
E.Implementation-Vendor
第9题:
Which of the following scenarios are likely reasons for an EtherChannel to fail?()
第10题:
The network administrator wants to enable an EtherChannel between two switches in "on" mode. The administrator connects the cables and enables the interfaces, but while configuring the EtherChannel in the first switch, a spanning-tree loop was detected. Which two of these procedures can avoid this problem?()