chkdsk
mount
fsck
diskpart
第1题：
An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash.Which of the following should the administrator do FIRST to troubleshoot the problem?（）
A. Check the backplane cabling.
B. Check the server BIOS.
C. Update the RAID controller firmware.
D. Install the latest hard drive firmware
第2题：
After performing the initial steps in installing the server OS from a DVD-ROM， the server reboots and goes back into the setup wizard. Which of the following is the MOST likely cause for this problem？（）
第3题：
A technician has had several support requests for one PC. The technician has reseated the PCIcards and replaced the hard drive in the PC located in a school cafeteria kitchen. PCs located in the business office or the classrooms have not had this issue.Which of the following is MOST likely causing this PC’s issue?（）
A. Faulty RAM
B. 240 volt Kitchen outlets
C. Power Brownouts
D. Excessive Heat
第4题：
A server has had a drive fail in its storage RAID set. The administrator swaps the drive with a replacement and the RAID set does not automatically start to rebuild the replaced drive. Which ofthe following utilities would MOST likely be used to initialize the rebuilding of the replace mentdrive？（）
第5题：
A server has lost communication to its drives located on a fiber channel SAN.An administrator notices that the indicator lights on both the HBA and the SAN switch are not lit.Which of the following are the MOST likely causes of the problem？（）
第6题：
An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. Theadministrator powers up the server， during POST the RAID controller is recognized but none of the drivelights flash. Which of the following should the administrator do FIRST to trouble shoot the problem？（）
第7题：
A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times， each of the replacement drives failed to power up and rebuild as the failed drive. Which of the following is the MOST likely cause of the failures？（）
第8题：
An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?（）
A. Processor failure
B. Third party memory
C. Disk drive failure
D. ESD during the upgrade
E. Backplane failure
第9题：
An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）
第10题：
A technician has had several support requests for one PC. The technician has reseated the PCIcards and replaced the hard drive in the PC located in a school cafeteria kitchen. PCs located in the business office or the classrooms have not had this issue. Which of the following is MOST likely causing this PC’s issue?（）