An administrator has removed a SATA hard drive from a failed

第1题：

After performing the initial steps in installing the server OS from a DVD-ROM， the server reboots and goes back into the setup wizard. Which of the following is the MOST likely cause for this problem？（）

• A、The DVD-ROM drive has failed.
• B、An installation file copied from the DVD to the hard drive is corrupt.
• C、Faulty OS installation DVD
• D、Incorrect boot sequence in the BIOS

第2题：

A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times， each of the replacement drives failed to power up and rebuild as the failed drive.  Which of the following is the MOST likely cause of the failures？（）

• A、 The backplane has failed and needs to be replaced.
• B、 The array must be disbanded and recreated from a backup source to recognize the replacement drive.
• C、 There is a conflict with the optical drive on the server.
• D、 The server power supply is failing and not providing enough power for all the drives.

第3题：

第4题：

An administrator is configuring RAID 1 in a server.  The administrator has been given two matching 80GB SATA-2 hard drives， two SATA-2 cables， and a SATA-2 RAID adapter.  How should the administrator BEST configure these drives？（）

• A、Install one drive on the first channel and install the second drive on the second channel.
• B、Install one drive on the first cable， on the first channel. Install the second drive on the secondcable， on the second channel.
• C、Install both drives on the same channel. Cable both drives as the primary master on the samecable.
• D、Install both drives on the same channel. On the same cable one drive should be set as primaryslave and the other drive as the primary master.

第5题：

An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）

• A、SATA to SCSI
• B、SATA to HBA
• C、SATA to USB
• D、SATA to SAS

第6题：

A technician has lost a necessary jumper for a new hard drive that must be installed immediately.Which of the following is the BEST solution?（）

• A、Use a jumper from the motherboard where the new drive is going to be installed.
• B、Use a jumper from a hard drive that is no longer functioning.
• C、Contact the manufacturer of the new hard drive and have a replacement jumper shipped immediately.
• D、The new hard drive must be replaced

第7题：

A server has lost communication to its drives located on a fiber channel SAN.An administrator notices that the indicator lights on both the HBA and the SAN switch are not lit.Which of the following are the MOST likely causes of the problem？（）

• A、Failed HBA
• B、Failed switch port
• C、Faulty fiber cable
• D、Faulty driver
• E、Failed hard drives
• F、Faulty configuration

第8题：

第9题：

An administrator has added a new hard drive to a server that is running out of space on its C Drive and is experiencing slow performance.  The administrator needs to free up space on the C Drive.Which of the following is the BEST action for the administrator to take to free up space on the drive？（）

• A、Move the page file to the new drive.
• B、Copy the system32 directory to the new drive.
• C、Convert the C drive to a basic disk.
• D、Setup a software RAID to mirror the C drive.

第10题：

A floppy drive is replaced in a computer and now when the computer is turned on the floppy drive light is constantly lit. Which of the following is the MOST likely cause?（）

• A、The power supply has failed.
• B、The drive cable is connected backwards.
• C、The floppy drive has failed.
• D、The proper drivers have not been loaded.