A network administrator needs to verify that switch interfac

题目
单选题
A network administrator needs to verify that switch interface 0/5 has been assigned to the Sales VLA.N. Which command will accomplish this task?()
A

Show vlan

B

Show mac-address-table

C

Show vtp status

D

show spanning-tree root

E

show ip interface brief

如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

An administrator replaced a router with a switch. End users are able to access network shares butare not able to access the Internet. Which of the following is the BEST explanation why the usersare unable to access the Internet?()

A. Router routes traffic between different networks and a switch does not

B. The new switch is faulty and needs to be replaced and configured correctly

C. The firewall needs to be setup to allow traffic to reach the Internet

D. The switch needs to be setup to forward data traffic to the Internet


参考答案:A

第2题:

The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?

A.Assign the switch a higher MAC address than the other switches in the network have

B.Establish a direct link from the switch to all other switches in the network

C.Configure the switch full-duplex operation and configure the other switches for half-duplex operation

D.Configure the switch so that it has lower priority than other switches in the network

E.None of the above


正确答案:D

第3题:

The network administrator has configured port security on a Ezonexam switch. Why would a network administrator configure port security on this Ezonexam device?

A.To prevent unauthorized hosts from getting access to the LAN

B.To limit the number of Layer 2 broadcasts on a particular switch port

C.To prevent unauthorized Telnet or SSH access to a switch port

D.To prevent the IP and MAC address of the switch and associated ports

E.None of the above


正确答案:A
解析:Explanation:
You can use the port security feature to restrict input to an interface by limiting and identifying MAC addresses of the stations allowed to access the port. When you assign secure MAC addresses to a secure port, the port does not forward packets with source addresses outside the group of defined addresses. If you limit the number of secure MAC addresses to one and assign a single secure MAC address, the workstation attached to that port is assured the full bandwidth of the port.

If a port is configured as a secure port and the maximum number of secure MAC addresses is reached, when the MAC address of a station attempting to access the port is different from any of the identified secure MAC addresses, a security violation occurs. Also, if a station with a secure MAC address configured or learned on one secure port attempts to access another secure port, a violation is flagged.

第4题:

You have just created a new VLAN on your network for inter-VLAN routing.  What is one step that you should include in your VLAN-based implementation and verification plan?()

  • A、Verify that different native VLANs exist between two switches for security purposes.
  • B、Verify that the switch is configured to allow for trunking on the switch ports.
  • C、Verify that each switch port has the proper IP address space assigned to it for the new VLAN. 
  • D、Verify that the VLAN virtual interface has been correctly created and enabled.

正确答案:B

第5题:

Refer to the exhibit.The network administrator normally establishes a telnet session with the switch from host A.However,host A is unavailable.The administrator′s attempt to the switch from host B fails,but pings to the other two hosts are successful.what is the issue?()

A.Host B and the switch need to be in the same subnet.

B.The switch needs and appropriate default gateway assigned.

C.The switch interface connected to the router is down.

D.Host B need to be assigned an IP address in vlan 1.

E.The switch interfaces need the appropriate IP addresses assigned.


参考答案:B

第6题:

The network administrator has just finished installing a new 10/100/1000 switch, but receives reports from the server administrator that servers connected to the new switch seem to be experiencing slow LAN connections. The network administrator checks the port connecting the new switch to the core switch and sees the following information:Which of the following is the MOST likely cause of the slow connections?()

A. The servers have not had VLAN tagging enabled on their NICs.

B. Speed and duplex have not been set.

C. VLAN tagging was not set on the trunk.

D. The servers have been connected with CAT5 cable.


参考答案:B

第7题:

A network administrator needs to verify that switch interface 0/5 has been assigned to the Sales VLA.N. Which command will accomplish this task?()

A. Show vlan

B. Show mac-address-table

C. Show vtp status

D. show spanning-tree root

E. show ip interface brief


参考答案:A

第8题:

The Ezonexam network administrator needs to verify that switch interface 0/5 has been assigned to the Marketing VLA.N. Which command will accomplish this task?

A. Show vlan

B. Show mac-address-table

C. Show vtp status

D. show spanning-tree root

E. show ip interface brief

F. None of the above


正确答案:A
A 解析:Explanation:
The "show vlan" command displays the configured vlan name and ID as well as the ports that belong to each VLAN, etc. By default all ports belongs to VLAN 1
Note: You can also use: show vlan brief, show vlan ID where ID is the VLAN ID.

第9题:

A network administrator needs to verify that switch interface 0/5 has been assigned to the Sales VLA.N. Which command will accomplish this task?()

  • A、Show vlan
  • B、Show mac-address-table
  • C、Show vtp status
  • D、show spanning-tree root
  • E、show ip interface brief

正确答案:A

第10题:

A network administrator needs to configure port security on a switch.which two statements are true?()

  • A、The network administrator can apply port security to dynamic access ports
  • B、The network administrator can configure static secure or sticky secure mac addresses in the voice vlan.
  • C、The sticky learning feature allows the addition of dynamically learned addresses to the runningconfiguration.
  • D、The network administrator can apply port security to EtherChannels.
  • E、When dynamic mac address learning is enabled on an interface,the switch can learn new addresses,up to the maximum defined.

正确答案:C,E

更多相关问题