The count parameter creates a counter that you can view with the show firewall command
The count parameter allows the router to count the number of pings for logging purposes
The count parameter allows the router to pause for 10000 seconds before sending out a ping
The count parameter allows the router to send out 1000 pings and then stop
第1题:
Refer to the exhibit. You have completed an OSPF implementation, and you are verifying OSPF operation. You notice that router A and router B are stuck in the two - way state. From the show ip ospf interface command output, what is the cause of this issue?()
A. All OSPF implementations must have at le ast one interface in area 0.
B. You are attempting to run in the broadcast mode over an NBMA interface.
C. Both routers are configured to function as a BDR; therefore, there is no DR router.
D. Someone has changed the OSPF router ID; therefore you must clear the OSPF process.
E. The OSPF priority is set to 0 on both routers; therefore neither can become the DR.
第2题:
A. Show interface lmi
B. Show frame-relay lmi
C. Show interface frame-relay
D. Debug frame-relay interface.
第3题:
A. There is a software issue with ge-1/0/1.0 interface.
B. There is a hardware issue with ge-1/0/1.0 interface.
C. The next hop of 172.25.213.11 is selected.
D. The next hop of 172.25.213.11 is not resolvable.
第4题:
You issue the ping interface t1-1/1/0 bypass-routing count 1000 rapid command. Which statement is correct?()
第5题:
While logged into a router you manually shut down the serial 0 interface using the "shutdown" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be?()
第6题:
While logged into a router you manually shut down the serial 0 interface using the "shutdown" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be?()
A. Serial 0 is up, line protocol is up
B. Serial 0 is up, line protocol is down
C. Serial 0 is down, line protocol is down
D. Serial 0 is down, line protocol is up
E. Serial 0 is administratively down, line protocol is down
F. Serial 0 is administratively down, line protocol is up
第7题:
Host 1 sends an ICMP echo request to remote sever1. Layer2 header of the frame containing the ping packet()。
第8题:
A.ping atm vci 0.100 interface at-0/1/0 end-to-end
B.ping atm vci 0.100 interface at-0/1/0 circuit
C.ping atm vci 0.100 interface at-0/1/0 far-end
D.ping atm vci 0.100 interface at-0/1/0 final-hop
第9题:
You issue the ping interface tl-1/1/0 1.1.1.1 bypass-routing count 1000 rapid command.Which statement is correct?()
第10题:
You issue the ping interface t1-1/1/0 1.1.1.1 bypass-routing count 1000 rapid command.Which statement is correct?()