You have been asked to configure your router to send link-related SNMP trap notifications to the network management system (NMS) located at address 172.16.17.1.Which two commands are required?()
第1题:
第2题:
A. router isis network 192.168.1.0 0.0.0.255
B. router isis network 192.168.1.0 255.255.255.0
C. interface atm 6/0.33 ip address 192.168.1.1 255.255.255.0 router isis
D. interface atm 6/0.33 ip address 192.168.1.1 255.255.255.0 ip router isis
第3题:
A.Local Security Policy
B.Scw
C.Secedit
D.Services console
第4题:
A.A
B.B
C.C
D.D
第5题:
A. set snmp trap-group my-trap-group targets 172.16.17.1
B. set snmp targets 172.16.17.1
C. set snmp trap-group my-trap-group link-status
D. set snmp trap-group my-trap-group categories link
第6题:
A. set snmp trap-group my-trap-group targets 172.16.17.1
B. set snmp targets 172.16.17.1
C. set snmp trap-group my-trap-group link-status
D. set snmp trap-group my-trap-group categories link
第7题:
A. user@router> request system storage cleanup
B. user@router> show system storage
C. user@router> request system storage cleanup dry-run
D. user@router> show system storage detail
第8题:
A new switch is being installed in the Ezonexam network and you have been assigned the task of connecting it to an existing switch. In doing this, you want to set up the VLAN Trunking Protocol so that VLAN information can be passed between the switches. Which of the following must you do to accomplish this? (Choose all that apply).
A.You must set each end of the trunk line to IEEE 802.1e encapsulation.
B.You must set the same VTP management domain name on both switches.
C.You must set all ports on the two switches as access ports.
D.You must configure one of the switches as a VTP server.
E.You must use a rollover cable to connect the two switches.
第9题:
A.set snmp trap-group my-trap-group link-status
B.set snmp trap-group my-trap-group categories link
C.set snmp log link-status
D.set snmp trap link-status
第10题:
Refer to the exhibit. A client has asked you to consult on an eBGP loading question. Currently the AS 100 eBGP links have an average outbound load of 65% and 20% respectively. On further investigation, traffic from 10.10.24.0 accounts for 45%, and 10.10.25.0 and 10.10.32.0 accounts for 20% each of the outbound load. The customer wants to spread the load between the two eBGP links more evenly. The BGP attributes are currently set at their default values. If you are located at AS 100 and want to influence how AS 100 sends traffic to AS 200, what BGP attribute could you configure to cause AS 100 outbound traffic to load the eB GP links more evenly? ()
A. On router A, set the default local - preference to 50.
B. On router B, set the default metric to 150.
C. On router B, configure a route map for 10.10.25.0/24 with a local preference of 150 linked to neighbor 192.168.30.2.
D. On router B, set the default local -preference to 150.