You issue the command telnet interface ge-1/1/0 10.10.10.1 source 192.168.100.1 bypass-routing. Which statement is correct?()
第1题:
You have two IP addresses configured on the ge-0/0/6 interface, as shown in the exhibit. You want to select the 172.16.10.101 address as the source address for packets sent from this interface to hosts on a remote subnet.Which parameter would you add to the 172.16.10.101 address to complete this task?()
A. preferred
B. broadcast
C. primary
D. arp 172.16.10.101
第2题:
A. The bypass-routing parameter is used to test the density on the TI line.
B. The bypass-routing parameter cannot be used on a T1 interface.
C. The bypass-routing parameter allows you to ping a host through an interface that has no route through it.
D. The bypass-routing parameter allows you to ping a local WAN interface without generating any outbound traffic
第3题:
Interface ge-0/0/2.0 of your device is attached to the Internet and is configured with an IP address and network mask of 71.33.252.17/24. A Web server with IP address 10.20.20.1 is running an HTTP service on TCP port 8080. The Web server is attached to the ge-0/0/0.0 interface of your device. You must use NAT to make the Web server reachable from the Internet using port translation.Which type of NAT must you configure?()
A. source NAT with address shifting
B. pool-based source NAT
C. static destination NAT
D. pool-based destination NAT
第4题:
When using the Cisco SDM Quick Setup Siteto-Site VPN wizard, which three parameters do you configure?()
第5题:
Which of the following descriptions about IP spoofing is correct?()
第6题:
A. The count parameter creates a counter that you can view with the show firewall command
B. The count parameter allows the router to count the number of pings for logging purposes
C. The count parameter allows the router to pause for 10000 seconds before sending out a ping
D. The count parameter allows the router to send out 1000 pings and then stop
第7题:
Your boss is learning a CCNA training course,refer to the exhibit.The access list has been configured on the S0/0 interface of router RTB in the outbound direction.Which two packets,if routed to the interface,will be denied?()access-list 101 denytcp192.168.15.320.0.0.15any eq telnetaccess-list 101 permitip any any
A.source ip address:192.168.15.5;destination port: 21
B.source ip address:,192.168.15.37 destination port: 21
C.source ip address:,192.168.15.41 destination port: 21
D.source ip address:,192.168.15.36 destination port: 23
E.source ip address:192.168.15.46;destination port: 23
F.source ip address:,192.168.15.49 destination port: 23
第8题:
A. The count parameter creates a counter that you can view with the show firewall command.
B. The count parameter allows the router to count the number of pings for logging purposes.
C. The count parameter allows the router to pause for 1000 seconds before sending out a ping.
D. The count parameter allows the router to send out 1000 pings and then stop.
第9题:
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()
第10题:
Which of the following statements are true concerning the command ip sla monitor responder typetcpconnect ipaddress 10.1.1.1 port 23?(Choose all that apply.)()