Your ERX Edge Router is using an inbound route-map for an EBGP peer to only accept routes in the range of 192.168.32.0 through 192.168.95.255. The route-map references an access list named test . What accurately accomplishes the goal of the route-map?（）
第1题：
A. reuse
B. suppress
C. half-life
D. max-suppress-time
第2题：
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines.What command would assign this access- list to the Virtual Terminal Lines?（）
A. router(config-line)# ip access-group 1 in
B. router(config-line)# access-class 1 in
C. router(config-line)# ip access-list 1 in
D. router(config-line)# access-line 1 in
第3题：
A. EXP bits
B. VPI / VCI
C. shim header
D. SNAP header
第4题：
一台路由器运行OSPF和RIP路由协议，现在需要将RIP中的路由引入到OSPF中，用到了Redistribute ripsubnets route-map的命令，如果这个route-map中最后的空语句忘记填写了，会出现什么情况？（）
第5题：
A.地址前缀列表（Prefix-list）
B.访问控制列表（Access-list）
C.团体属性列表（Community-list）
D.路由映射表（Route-map）
第6题：
A.A
B.B
C.C
D.D
第7题：
A.prefix-list，route-map，filter-list，distributelist
B.route-map，filter-list，prefix-list，distribute-list
C.route-map，distribute-list，prefix-list，filter-list
D.filter-list，prefixlist，route-map，distributelist
E.distributelist，prefix-list，route-map，fitterlist
第8题：
Your ERX Edge Router is using an inbound route-map for an EBGP peer to only accept routes in the range of 192.168.32.0 through 192.168.95.255. The route-map references an access list named test .What accurately accomplishes the goal of the route-map?（）
A. access-list test 192.168.32.0 0.0.63.255
B. access-list test permit 192.168.32.0 0.0.64.255
C. access-list test permit 192.168.32.0 0.0.63.255
D. access-list test permit 192.168.32.0 255.255.63.0
第9题：
配置策略路由时，需要在接口下通过路由图名字调用已配置的route-map，路由器上有个route-map的名字叫abc，下列配置中正确的是（）
第10题：
What is the order of preference for these commands when all of them are applied to one neighbor in theBGP inbound filter direction？（）