You want your Catalyst switch to implement a switching method that holds a packet in its memory until the data portion of the respected packet reaches the switch.Which method should you employ on your Catalyst switch?()
第1题:
You are a network administrator for your company. You currently automate backups of the System State data on the servers in your network by using NTBackup. Your manager instructs you to document the procedure for restoring a server from a backup of the System State data.You need to select the correct method for performing a restoration of a backup of the System State data.What should you do?()
A. Run the following command: ntbackup.exe backup /F {"FileName"}
B. Run the following command: ntbackup.exe backup systemstate /F {"FileName"}
C. In Control Panel, open System, and configure the Startup and Recovery settings on the Advanced tab.
D. Use NTBackup interactively.
第2题:
You want your Catalyst switch to implement a switching method that holds a packet in its memory until the data portion of the respected packet reaches the switch.Which method should you employ on your Catalyst switch?()
A. Fast Forward
B. Store and forward
C. Frag-free
D. None of the above
第3题:
You wish to segment your LAN into multiple broadcast domains. Which technology method should you implement in order to do this?
A. Transparent bridging
B. Cut-through switching
C. Fragment-free switches
D. Virtual LANs
E. Store-and-forward switching
F. None of the above
第4题:
Assuming the default switch configuration,which approach should you use to configure the extended vlan range(1006 through 4094) on a cisco catalyst 3750 series switch?()
第5题:
You are bringing up a new Cisco Catalyst switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method.When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?()
A. Switch(config)# switchport trunk encapsulation isl
B. Switch(config)# switchport trunk encapsulation ietf
C. Switch(config-if)# switchport trunk encapsulation isl
D. Switch(config-if)# switchport trunk encapsulation ietf
E. Switch(config-if)# switchport trunk encapsulation dot1q
第6题:
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?()
A. The switch name must match the workgroup name of the local network.
B. The switch must be configured with an IP address and default gateway.
C. The remote workstations must have access to the management VLAN of the switch.
D. CDP must be enabled on the switch so that it can be located by other devices on the network.
第7题:
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303
第8题:
a. on
b. off
c. up
第9题:
A. Configure the switch to be in VTP client mode.
B. Configure the switch to be in VTP domaint mode.
C. Configure the switch to be in VTP transparent mode.
D. Configure the switch to be in VTPv2.
第10题:
You are at a client site. It is a medium-sized business and needs a Cisco Catalyst switch that offers high availability and security. What type of Catalyst switches would you recommend?()