In an Ethernet network, under wh

题目

In an Ethernet network, under what two scenarios can devices transmit?()

  • A、when they receive a special token
  • B、when there is a carrier
  • C、when they detect no other devices are sending
  • D、when the medium is idle
  • E、when the server grants access
如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

Refer to the exhibit. A network administrator has configured DHCP services on the router asshown. DHCP clients connected to the FastEthernet0/0 interface are working properly. DHCP clients connected to the FastEthernet0/1 interface are not receiving addresses.Which two statements contain recommendations that will solve the problem?()

A.The network shown in the output under the ip dhcp pool Central command should be changed to network 10.10.0.0 with a mask of 255.255.255.0

B.A second DHCP pool for network 10 .10.0.0/24 should be configured

C.An ip dhcp excluded - address global configuration command for network 10.10.0.0/24 should be issued

D.The ip helper -address 10.0.0.1 command should be issued so that the address can be added to the Fast Ethernet0/0 c onfiguration

E.The ip helper -address 10.0.0.1 command should be issued so that the address can be added to the Fast Ethernet0/1 configuration


参考答案:B, C

第2题:

Which two of these are characteristics of Metro Ethernet? ()

A. class of service

B. bandwidth profiles

C. user-network interface

D. Ethernet LAN circuit attributes

E. Ethernet virtual circuit attributes


参考答案:C, E

第3题:

While troubleshooting an issue in the Ezonexam LAN you notice that a network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?

A. This is an Ethernet port operating at half duplex

B. This is an Ethernet port operating at full duplex

C. This is a port on a network interface card in a PC

D. This is 10 MB/s switch port

E. This is a 100 MB/s switch port

F. None of the above


正确答案:A
A

第4题:

A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?()

  • A、This is a 10 Mb/s switch port.
  • B、This is a 100 Mb/s switch port.
  • C、This is an Ethernet port operating at half duplex.
  • D、This is an Ethernet port operating at full duplex.
  • E、This is a port on a network interface card in a PC

正确答案:C

第5题:

Ethernet is the commonly used local area network communication protocol. The standard of Ethernet is ( ) .

A.IEEE 802.1
B.IEEE 802.2
C.IEEE 802.3
D.IEEE 802.11

答案:C
解析:

第6题:

Which one of the following actions would actually increase congestion on an Ethernet network?()

A. Increasing the number of collision domains.

B. Micro-segmenting the network.

C. Adding hubs for connectivity to the network.

D. Putting additional switches in the network.

E. Implementing VLANs in the network.


参考答案:C

第7题:

In an Ethernet network, under what two scenarios can devices transmit?()

A. when they receive a special token

B. when there is a carrier

C. when they detect no other devices are sending

D. when the medium is idle

E. when the server grants access


参考答案:C, D

第8题:

With regard to Ethernet media access methods, which of the following are true?

(Choose all that apply.)

A.A device waits for an electronic signal before transmitting.

B.A device listens and waits until the media is not busy before transmitting.

C.All devices on an Ethernet segment see data that passes on the network medium.

D.Only the sender and the receiver devices see data that passes on the network medium.

E.Ethernet networks allow you to configured devises with higher transmission priority.


正确答案:BC
解析:Explanation:
Ethernet uses the CSMA/CD access method.
CSMA/CD logic helps prevent collisions and also defines how to act when a collision does occur. The CSMA/CD algorithm words like this:
1. A device with a frame. to send listens until the Ethernet is not busy.
2. When the Ethernet is not busy, the sender begins sending the frame.
3. The sender listens to make sure that no collision occurred.
4. Once the senders hear the collision, they each send a jamming signal, to ensure that all stations recognize the collision.
5. After the jamming is complete, each sender randomizes a timer and waits that long.
6 When each timer expires, the process starts over with Step 1.
So, all devices on the Ethernet need to use CSMA/CD to avoid collisions and to recover when inadvertent collisions occur.

第9题:

A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port()。

  • A、This is a 10 Mb/s switch port
  • B、This is a 100 Mb/s switch port
  • C、This is an Ethernet port operating at half duplex
  • D、This is an Ethernet port operating at full duplex
  • E、This is a port on a network interface card in a PC

正确答案:C

第10题:

A workstation would MOST likely be connected to an office network using which of the followingcable types?()

  • A、eSATA
  • B、Bluetooth
  • C、SCSI
  • D、Ethernet

正确答案:D

更多相关问题