Which EIGRP feature should a designer consider to limit the scope of EIGRP queries andminimize convergence time？（）
第1题：
A. TK1#show ip eigrp adjacency
B. TK1#show ip eigrp topology
C. TK1#show ip eigrp interfaces
D. TK1#show ip eigrp neighbors
E. None of the above
第2题：
A. debug eigrp packets
B. show ip eigrp traffic
C. debug ip eigrp
D. show ip eigrp interfaces
第3题：
A. IS-IS, EIGRP, SSO, BGP
B. ISSU, OSPF, IS-IS
C. IETF, OSPF, ISSU
D. EIGRP, BGP, OSPF, IS-IS
第4题：
You are using IPv6， and would like to configure EIGRPv3. Which three of these correctly describe how you can perform this configuration？（）
第5题：
Which of the following is true regarding the effect of EIGRP queries on the network design？（）
第6题：
A.Jitter
B.Delay
C.MTU
D.Reliability
第7题：
A.EIGRP converges fast RIP because of DUAL and backup routes that are stored in the topology table.
B.EIGRP uses a hello protocol to establish neighbor relationships
C.EIGRP uses split horizon and reverse poisoning to avoid routing loops.
D.EIGRP uses periodic updates to exchange routing information
E.EIGRP allows routers of different manufacturers to interoperate
F.EIGRP supports VLSM and authentication for routing updates.
G. EIGRP use a broadcast address to send routing information.
第8题：
A. Under t he router eigrp mode add redistribute igrp 123 subnets
B. Under the router igrp mode add redistribute eigrp 123
C. None, EIGRP and IGRP are automatically redistributed in this instance.
D. Under the router eigrp mode add redistribute igrp 123
第9题：
Which protocol is used by multicast to prevent loops?（）
第10题：
Which two EIGRP options will limit a query domain？（）