单选题An administrator plans to attach an IBM DS6000 and needs to know if the fibre channel adapter is at the latest firmware level.  Which of the following is the fastest way for the administrator to determine the  atest supported microcode level （）A Call T

第1题：

An administrator recently installed a known good RAID adapter.  During boot up， the administrator is able to access the RAID configuration utility； however， when the administrator checks for the card in the operating system， it does not show up.  Which of the following should the administrator do FIRST？（）

• A、Move the RAID adapter to another slot.
• B、Perform a baseline of the system.
• C、Contact the reseller of the adapter for a replacement card.
• D、Check the RAID adapter’s manufacturer for the latest drivers.

第2题：

An administrator needs to determine what the default run level of a system is.  Which command would be used（）

• A、Isitab init
• B、telinit -d
• C、cat/etc/.init.state
• D、init

第3题：

第4题：

A system administrator has been instructed to attach storage in their client LPARs, in a Power 770, with fibre channel adapters using N_port ID virtualization (NPIV). Which of the following partitions has the minimum requirements to utilize virtual fibre channel?（）

• A、LPAR-A with 1Gb FC HBA and SAN connection
• B、LPAR-B with 2Gb FC HBA and SAN connection
• C、LPAR-C with 4Gb FC HBA and SAN connection
• D、LPAR-D with 8Gb FC HBA and SAN connection

第5题：

An administrator has a malfunctioning uninterruptible power supply (UPS). Which of the following is the MOST likely cause of the problem?（）

• A、Battery needs to be replaced
• B、Light switch is turned off
• C、Smart cable is disconnected
• D、UPS needs a firmware update

第6题：

An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash. Which of the following should the administrator do FIRST to troubleshoot the problem?（）

• A、Check the backplane cabling.
• B、Check the server BIOS.
• C、Update the RAID controller firmware.
• D、Install the latest hard drive firmware

第7题：

An administrator needs to connect servers to the Fiber Channel SAN. Which of the following should the administrator install in the servers to allow this connection？（）

• A、Riser
• B、HBA
• C、SCSI card
• D、SAS card

第8题：

第9题：

A customer has defined their server needs as a four-LPAR 16-way p570 with 64GB of memory， four 10/100/1000 TX LAN adapters， and six fibre channel adapters to external storage in an IBM ESS （Shark）.  They like the idea of being able to do SAN maintenance while not incurring downtime.  If all LPARs are production related and similar， which question is most appropriate for the pSeries technical specialist to ask？（）

• A、Would 10/100 Ethernets work as well？
• B、Should there be eight fibre channel adapters？
• C、Should there be an async adapter for heartbeat？
• D、Will all LPARs need access to a common fibre channel tape drive？

第10题：

A system administrator has just installed a new maintenance level， but "oslevel -r" does not show the correct maintenance level. What command can be used to determine which filesets are downlevel？（）

• A、lppchk
• B、instfix
• C、fixdist
• D、maintlvl