set protocols set ospf area 0 set interface so-0/0/0.100
set protocols ospf area 0 interface so-0/0/0.100
edit protocols ospf interface so-0/0/0.100
edit protocols ospf area 0 set interface so-0/0/0.100
第1题:
Refer to the exhibit. You have completed an OSPF implementation, and you are verifying OSPF operation. You notice that router A and router B are stuck in the two - way state. From the show ip ospf interface command output, what is the cause of this issue?()
A. All OSPF implementations must have at le ast one interface in area 0.
B. You are attempting to run in the broadcast mode over an NBMA interface.
C. Both routers are configured to function as a BDR; therefore, there is no DR router.
D. Someone has changed the OSPF router ID; therefore you must clear the OSPF process.
E. The OSPF priority is set to 0 on both routers; therefore neither can become the DR.
第2题:
A. All OSPF networks require the use of multiple areas
B. Multiple OSPF areas must connect to area 0
C. Single area OSPF networks must be configured in area 1
D. Areas can be assigned any number from 0 to 63535
E. Area 0 is called the backbone area
F. Each OSPF area need to be configured with a loopback interface
第3题:
You want to allow your device to establish OSPF adjacencies with a neighboring device connected to interface ge-0/0/3.0. Interface ge-0/0/3.0 is a member of the HR zone.Under which configuration hierarchy must you permit OSPF traffic?()
A. [edit security policies from-zone HR to-zone HR]
B. [edit security zones functional-zone management protocols]
C. [edit security zones protocol-zone HR host-inbound-traffic]
D. [edit security zones security-zone HR host-inbound-traffic protocols]
第4题:
You are the top of hierarchy and must configure OSPF on inteface so-0/0/0 unit 100. Which two achieve this result?()
第5题:
You wish to configure IPv6 support on a router which does not have any current IPv4 configuration.Which three steps are used to configure IPv6 with an accompanying IGP in JUNOS software? ()
第6题:
A. Hierarchical OSPF networks need to be in one area
B. Multiple OSPF areas must connect to area 0
C. Single area OSPF networks must be configured in area 1
D. Areas can be assigned any number from 0 to 63535
E. Area 0 is called the backbone area
F. Each OSPF area need to be configured with a loopback interface
第7题:
第8题:
A. set protocols isis inet6
B. set routing-options router-id router-id
C. set protocols ospf3 area 0 interface all
D. set interface fe-0/0/1 unit 0 family inet6
E. set routing-options ipv6-router-id router-id
第9题:
Which two commands would change the default OSPF metric calculation for interface ge-0/3/0 in JUNOS software?()
第10题:
You are at the top of the hierarchy and must configure OSPF on interface so-0/0/0 unit 100.Which two achieve this result?()