The following configura tion exists on a router on one end o

第1题：

第2题：

Exhibit: The following are true with one of the TestKing routers: 1) The IOS image in flash is missing 2) No Network connectivity is available. 3) The router fallback IOS image is corrupt. How will this Cisco 2600 series router respond if the conditions listed in the exhibit exist during the boot process?（）

• A、The router will enter setup mode.
• B、The router will enter ROM monitor mode.
• C、The router will enter global configuration mode.
• D、The boot will hang until an IOS is available.

第3题：

第4题：

Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable RIPng and IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Which of the following is true about RIPng on R1 after this configuration has been pasted into R1?（） ipv6 unicast- routing interface f0/0 ipv6 rip one enable ipv6 address 2000::1/64 interface s0/0/0 ipv6 address 2001::/64 eui - 64 ipv6 rip one enable

• A、RIPng will be enabled on no interfaces.
• B、RIPng will be enabled on one interface.
• C、RIPng will  be enabled on two interfaces.
• D、RIPng will advertise about prefixes connected to S0/0/0 and F0/0, but only send Updates on one interface.

第5题：

You are planning a new VLAN-based network solution.  What is one item you should consider when creating your implementation plan as it concerns VLANs？（）

• A、generic router and switch configuration parameters
• B、end-to-end test plan after all components have been installed and  configured
• C、administrator assignments
• D、rollback plan

第6题：

A company has a Frame Relay WAN with one central - site router and 100 branch office routers. A partial mesh of PVCs exists: one PVC between the central site and each of t he 100 branch routers. All routers use point - to - point subinterfaces and one subnet per PVC. Which of the following is true about OSPF in this design?（）

• A、The central site router has 100 fully adjacent neighborships with the 100 branches
• B、The central  site router has neighborships with all branch routers, but fully adjacent neighbors with only two branches
• C、The central site router has a neighborship with the Frame Relay switcH
• D、None of the other answers is correct

第7题：

Which router or router combination is used to calculate the MPLS traffic engineering tunnel path？（）

• A、head-end router and tail-end router
• B、middle-point router
• C、head-end router
• D、tart-end router
• E、tail-end router

第8题：

第9题：

The following configura tion exists on a router on one end of an IPv6 tunnel. Which type of tunnel is created by this configuration?（） interface loopback 1 ip address 1.1.1.1 255.255.255.255 interface tunnel 2 ipv6 address 2000::1::/64 tunnel source loopback 1 tunnel destina tion 2.2.2.2 tunnel mode ipv6ip ipv6 eigrp 1

• A、Automatic 6to4
• B、Manually configured tunnel
• C、ISATAP
• D、GRE

第10题：

The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（） interface loopback 1 ip address 192.168.1.1 255.255.255.255 interface tunnel 2 ipv6 address 2002:C0A8:10 1::1/64 tunnel source loopback 1

• A、Automatic 6to4
• B、Manually configured tunnel
• C、ISATAP
• D、GRE