Packets are distributed across the ports in the channel based on both the source and destination MAC addresses.
Packets are distributed across the ports in the channel based on both the source and destination IP addresses.
Packets are balanced across the ports in the channel based first on the source MAC address， then on the destination MAC address， then on the IP address.
Packets are distributed across the access ports in the channel based first on the source IP address and then the destination IP addresses.
第1题：
What is the result of entering the command spanning-tree loopguard default？（）
第2题：
What interface is created when an FC Port Channel is created on a Cisco Unified Computing System？（）
第3题：
A.The route is a direct route.
B.The route was selected as active.
C.The route is a default route.
D.The route was learned using a dynamic routing protocol.
第4题：
Which command is used to enable EtherChannel hashing for Layer 3 IP and Layer 4 port-based CEF？（）
第5题：
When you display the routing table by entering the show route command, what does the* indicate?（）
第6题：
What is the main reason for using the "ip ips deny-action ips-interface" IOS command？（）
第7题：
Which command is used to load the rescue configuration?（）
第8题：
A. Only the path that is the feasible successor should be used.
B. Load balancing is disabled on t his router.
C. The router only performs equal - cost load balancing on all paths that have a metric greater than 1
D. The router performs equal - cost load balancing.
第9题：
What is the meaning of the default value of the EIGRP variance command of 1? （）
第10题：
What will be disabled as a result of the no service password-recovery command？（）