When is a first-hop redundancy protocol needed in the distribution layer?()
第1题:
A. OSPF is not supported by the design
B. HSRP is not supported by the design
C. preempt tuning of the default gateway is needed
D. the design implements Layer 3 between the access switch and the distribution switch
第2题:
Which first-hop redundancy solution listed would supply Company clients with MAC address0000.0C07.AC0A for group 10 in response to an ARP request for a default gateway?()
第3题:
A.Bus
B.Mesh
C.Multipath
D.Ring
第4题:
You want to implement router redundancy in the Company network using the best method available. Which protocol specified by RFC 2281 provides network redundancy for IP networks, ensuring that user traffic immediately and transparently recovers from first-hop failures in network edge devices or access circuits?()
第5题:
You need to design router redundancy on the Company network. Which three protocols could be chosen for IP routing redundancy to protect against first-hop router failure?()
第6题:
During testing of network redundancy in a fully meshed enterprise campus, a problem has been reported. Both distribution multilayer switches are fully configured for redundancy; clients operate normally when the primary multilayer distribution switch is operating. All clients drop connections outside of their respective access layer group when the primary distribution switch is shut down and the secondary distribution switch is still operational. Additional information indicates that the secondary distribution switch is able to ping major corporate and Internet locations. Which item would be the best point of troubleshooting for this connectivity issue? ()
第7题:
What is the correct sequence of commands to configure and verify SRM with SSO redundancy? ()
第8题:
A. mode sso, redundancy, show redundancy states
B. show redundancy states, mode sso, redundancy
C. redundancy, mode sso, show redundancy states
D. show redundancy states, redundancy, mode sso
第9题:
Which two statements are true regarding redundancy groups? ()(Choose two.)
第10题:
To protect against first-hop router failure, four protocols were developed to ensure IP routing redundancy. Which of the following are they?()